Worktop templating in Upton Park

Yes. Upton Park is on the patch, and the postcodes we work here are E13, E6. It is worked on our east London run, along with the rest of Newham. Streets near a ground or a venue have restrictions that come and go with the fixture list rather than with the time of day. The templating visit needs somewhere to stop for two or three hours, which is a different problem from unloading for twenty minutes. Two hours is the realistic figure. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Access is a question about the plot rather than the house: a narrow frontage between older buildings with nowhere obvious to stand a van. The template records that corner as it is, so the mitre closes tight instead of being cut to a theoretical 90 degrees. Recorded as it is, not as it was drawn. Heavy cooking use here means people want deep upstands and a solid splashback behind the range, not a 6mm glass panel.

The market street and the surrounding shopping parades are congested through the day with loading restrictions, so residential drops are best mid-morning off the side streets. The redeveloped stadium site apartments have their own service entrance and lift booking system, quite unlike the terraces around them. Piece length is set by the internal diagonal of the lift car, not by the length of the slab. Door widths, turn diagonals and any change of level are recorded on the drawing alongside the run dimensions. It goes on the drawing with the run dimensions.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop installation, worktop splashbacks & upstands and worktop design & quotation. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. Where an annexe has been built or converted, its floor and its walls are newer than the main house and behave differently under the same run. Two to three hours on site, with the sink, tap and hob physically present. The room as it is, not as it was drawn.

Galley runs are usually short enough to come out of a single slab, so the material band you choose does more to the total than the room shape does. A layout templated off one wall instead of one datum will not sit right once all the pieces are down together. One datum for the whole room. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Taped internal angles in plasterboard belly at the corner, so the run picks up a few millimetres over the last 300mm and a plan-angle mitre will not close. The template plots it as it is, at the exact height the worktop will sit, and the drawing carries that through. Measured at worktop height, nowhere else. Boards taped or skimmed and finished, units fixed back to the wall and levelled off, and the appliances on site - the wall must be at its final thickness on template day, so no tiler or splashback fitter gets ahead of the worktop. A street with houses in single occupation next to the same houses cut into flats produces two completely different jobs from the same elevation. The template happens when the units are in, fixed and level, whoever is fitting them. No stone is cut from a plan.