Worktop installation in Queenhithe

Yes. Queenhithe is on the patch, and the postcodes we work here are EC4V, EC4R. It is worked on our the City run, along with the rest of the Square Mile. A red route means no stopping, and no stopping means exactly that, so the stone comes in from a side street or from a bay behind the property. The fitting slot is set around it, which is why we ask about it when the date is booked and not before we leave the yard. It is why the arrival time is what it is. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Open-plan living makes the kitchen furniture rather than utility, so the island and the run behind it are nested off the same area of slab. The lift is measured before the piece is loaded, and once inside the flat the fitting is quick by comparison. That is the shape of the day. Old inset hob and sink cut-outs never match modern appliance dimensions, so confirm the new appliances before templating or you will be cutting an oversized hole to hide an old one.

Upper Thames Street runs below and alongside as a fast dual carriageway with no stopping whatsoever, so access is via the raised riverside walk and a building's own service entrance off a side street. The walk from the nearest permitted stopping point to the flat door can be long and partly on a raised deck with steps, so a route survey matters more than the lift dimensions. The lift has to be booked and blanketed before anything moves, and that booking needs to cover the old tops coming out as well as the new stone going in. The fitting day is planned backwards from that point, before anything comes off the van. That is what the morning is planned around.

It is one of the three we do most here, behind worktop replacement. Same template visit, same workshop, same installers either way. Housings and integrated appliances are set out for a 38mm laminate top, so dropping to 20mm or 30mm stone changes the clearances and needs checking before anything is cut. The fitting day is scheduled to suit that rather than to suit the diary. The prep list is not optional. Upgrading a builder-finish kitchen is mostly a swap, so the cost sits in the material choice rather than in the shape of the room. Where the window is fixed there is no second day to fall back on, so the prep list matters more than usual. One visit, done properly.

The free end is what needs deciding early: square edge, mitred apron down the end, or a full waterfall to the floor, and a waterfall is cut in sequence off the same part of the slab. A layout that has been packed and levelled run by run instead of to one datum shows as a step where two pieces meet. Nothing is bonded until the whole run sits flat. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A chimney breast left in place splits a wall into two alcoves, and the two are rarely the same width and rarely parallel to each other. On the day it means dry-laying, marking, and cutting the scribe on site before anything is bonded. Eased in, never forced. Book the service lift and loading bay with the building manager for the whole fitting window, and have the fob or key for lift override ready. The same building type can arrive as a careful one-off kitchen or as a fast turnaround, and the honest answer is that they are priced differently. The fitting day is arranged with whoever can actually give us access for the whole slot. Access for the whole slot, or a different day.