Worktop design and quotation in Queen's Park

Yes. Queen's Park is on the patch, and the postcodes we work here are NW6, NW10. It is worked on our north west London run, along with the rest of Brent. Permit hours are what matters, not the permit itself, because a bay that frees up at six in the evening is no use for a template at ten. Where a bay suspension or a permit is needed, that is a real cost and it goes on the quote instead of appearing later. You are told before you commit to a date. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Where the side return has been filled in, the old external wall is now an internal one and still carries its render, its gutter line and its old fixings. The kitchen is usually a long galley in a rear extension or side return, so the run lengths are the first thing we check against slab length, anything beyond roughly three metres either needs a join or a second slab, and that decision alone moves the material figure more than a few extra square metres would. Priced from the building, not from a rate card. Because the side return has been built over, there is no side access left on most of these houses, so hall width and the stair newel decide the maximum piece.

Conservation-area streets with no dropped kerbs and permit parking enforced all day, and side returns are built out, so almost every slab goes through the front door and along a narrow hall with a return at the stairs. A walk-up with winders at every half-landing means the piece is rested and re-gripped on the way, so the crew size goes up before the piece size comes down. That is why the fitting line on a quote reflects manpower and time rather than square metres. Nothing about it gets estimated after the fact.

It is one of the three we do most here, behind worktop installation. Same template visit, same workshop, same installers either way. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. That changes what the quote should be compared against, because the shape of the job is not the same as a single family kitchen. Itemised, so it can be compared honestly. Extension kitchens are usually specified long before they are buildable, so the run lengths on the drawing and the run lengths in the room are different numbers. Comparing quotes only works when they itemise the same things, and this is where the differences usually hide. Material is the slab only, and it says so.

Seating overhangs past roughly 300mm will not carry on the carcass alone, so flat steel bar or a plywood substrate has to be built into the units first. Each run is priced on its own line against the supply rate, with the join count and the reason for each join stated. Shape first, area second. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

The stone carries the scribe because the wall cannot be persuaded, so back edges are cut oversize and eased in rather than dropped straight down. It is fabrication time rather than material, so it appears on the fabrication line and not in the square metre figure. Priced as fabrication, not as area. Send us the run lengths, plus photos taken walking from the pavement through the hall to the kitchen so we can see the door widths and the stair turn. The same building type can arrive as a careful one-off kitchen or as a fast turnaround, and the honest answer is that they are priced differently. The quote is written so it can be read by whoever is paying rather than only by whoever is standing in the kitchen. Every line has a reason next to it.