Kitchen worktops in Richmond

Yes. Around the Green and the town it is mostly flats and maisonettes - Georgian upper floors with kitchens squeezed into former dressing rooms, and mansion blocks with narrow galleys of 2.4m to 3m where a slimline 20mm top is chosen to keep the run feeling wider. A controlled parking zone means either a visitor permit sorted in advance or a suspended bay, and a suspension is applied for days ahead rather than on the morning. Waste is the part people forget: the old laminate or tired granite has to be walked back to the van and it does not get lighter. The waste run is planned, not improvised.

Georgian terrace, Victorian terrace, Edwardian mansion block and 1990s riverside apartments. The flat entrance door and the internal doorways are usually tighter than the communal stairs, which is the opposite of what most people assume. The day is planned backwards from the hall. Walked, measured, protected, then lifted.

Conservation-area frontages with railings and steps, a strict CPZ with short-stay bays only, and a town centre that clogs at weekends; several riverside blocks flood-plan their basements, so lift access is from an upper lobby. The lift has to be booked and blanketed before anything moves, and that booking needs to cover the old tops coming out as well as the new stone going in. Finding it out on the morning costs the whole slot, because there is no second route to fall back on. That is what the morning is planned around.

Worktop replacement, worktop templating and worktop installation, in that order. Where a single building holds several small kitchens, the work arrives as one job rather than four, and it should be cut off the same slab run so the batches genuinely match. The units stay and only the surface changes, so the whole job is one day rather than a kitchen refit. A day, not a project. Georgian upper-floor flats have springy timber floors, so the units need levelling and packing before the top goes on or the joint opens within a month.

Two parallel runs with a walkway between them is the most efficient shape there is on a slab, because both pieces nest as straight lengths with almost no waste. On the day that means dry-laying the whole layout first and only then pulling and bonding the joins. Dry-lay first, always. Level has to hold across the whole room rather than along one wall, or a floor that falls end to end shows as a step where two pieces meet. The template plots it as it is, at the exact height the worktop will sit, and the drawing carries that through. Measured at worktop height, nowhere else. Material runs from £110 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines rather than rolled into one figure.

Where ownership is split across a building, the common parts belong to someone else and the carry route is negotiated rather than assumed. If the carcasses are tired the honest answer is that stone will find that out, and it is better said before than after. Sound carcasses are the condition. Tell us the building when you book and the lift, the stair turn and any freeholder notice get built into the day rather than found on it.