Worktop replacement in Richmond

Yes. Richmond is on the patch, and the postcodes we work here are TW9, TW10. It is worked on our south west London run, along with the rest of Richmond upon Thames. Enforcement zones rarely accept a trade van unloading stone as an exemption, so this gets sorted before the date is confirmed rather than argued about afterwards. A replacement is a two-way job, with old tops going out and new stone coming in, so the van needs to stay put across the whole day. Old tops out and new stone in, both through the same gap. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

A villa cut into flats leaves kitchens in rooms that were never kitchens, with services run to wherever they could physically be made to reach. In most Victorian terraces the kitchen sits in the back addition, so you get a narrow galley with one outside wall and nothing square to work off. What is under the old top is the real question. Georgian upper-floor flats have springy timber floors, so the units need levelling and packing before the top goes on or the joint opens within a month.

Conservation-area frontages with railings and steps, a strict CPZ with short-stay bays only, and a town centre that clogs at weekends; several riverside blocks flood-plan their basements, so lift access is from an upper lobby. A car that takes 2.4m on the diagonal will not take a three-metre worktop however it is stood, and there is no trimming it on the landing. With no room to turn, the old top gets cut up in the kitchen instead, which is dusty work and needs the room emptied first. It sets what the day actually looks like.

Yes. On the research for this patch it is the first of the three jobs listed, ahead of worktop templating and worktop installation. Where a single building holds several small kitchens, the work arrives as one job rather than four, and it should be cut off the same slab run so the batches genuinely match. The units stay and only the surface changes, so the whole job is one day rather than a kitchen refit. A day, not a project. Small kitchens in a shared house are all short runs and tight cut-out spacing, which is more bench work per square metre than one large kitchen would be. Old tops out in the morning, new stone down and sealed the same afternoon. A day, not a project.

Galley runs are usually short enough to come out of a single slab, so the material band you choose does more to the total than the room shape does. Going from a 38mm laminate to 20mm or 30mm stone drops the surface, which shows against tiles, a window board and any freestanding appliance. Carcasses have to be sound first. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Legs bottoming out on hard concrete or an uneven screed mean the tops of the carcasses are not one plane, and that is picked up at template rather than on fitting day. The old top has been hiding it, so the first honest look at it happens when the laminate comes off. It is the usual surprise, and it is a known one. Have a plumber booked to disconnect the sink, tap and waste first thing and reconnect after we have gone, and clear the hallway and stairs completely so we can carry slabs through the house. A street with houses in single occupation next to the same houses cut into flats produces two completely different jobs from the same elevation. A plumber disconnects before we arrive and reconnects after we leave, and that is worth booking early. Units kept, surface changed.