Kitchen worktops in Rise Park

Yes. A settled inter-war estate of repeating semi pairs where kitchens sit at the rear with the original larder and back door arrangement, and most owners extend modestly rather than remodel wholesale. Typical outcome is an L-shaped kitchen with the hob on the long wall and a small peninsula, and clients here often keep a separate dining room rather than going fully open-plan. Off-street parking means the van stays put all day, so tools, packers and the offcut we would rather have than not are all within reach. A replacement is a two-way job, with old tops going out and new stone coming in, so the van needs to stay put across the whole day. Old tops out and new stone in, both through the same gap.

1930s semi, post-war semi and 1960s detached. Runs are short enough that a single slab covers the whole kitchen, which makes the material choice the main lever on the total. What catches people out is the junction between the old floor and the extension floor, which is rarely at the same level, so a run carrying across it needs the units packed before stone goes on. What is under the old top is the real question.

Wide, quiet roads with driveways and dropped kerbs almost throughout, plus side gates giving a clean route to the rear extension without going through the house. Garden routes carry their own hazards: a drain cover, a step up to a patio, wet decking, or a lawn that will not take a loaded trolley. Worth remembering that the old tops have to come out the way the new ones come in, and a laminate run is easier to remove in one length than to carry in one. The strip-out is planned around it.

Worktop installation, worktop replacement and worktop templating, in that order. Extension kitchens are usually specified long before they are buildable, so the run lengths on the drawing and the run lengths in the room are different numbers. The carcasses have to be sound, because stone is several times the weight of what is coming off. A day, not a project. Because the layouts repeat across the estate we can usually predict the room, but the extensions vary wildly in squareness so nothing gets cut off a drawing.

Two runs meeting at an internal corner is the most common shape we fit, and the corner is where the decisions are. A layout that has been packed and levelled run by run instead of to one datum shows as a step where two pieces meet. Dry-lay first, always. Level has to hold across the whole room rather than along one wall, or a floor that falls end to end shows as a step where two pieces meet. The template plots it as it is, at the exact height the worktop will sit, and the drawing carries that through. Measured at worktop height, nowhere else. Material runs from £110 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines rather than rolled into one figure.

The householder is normally on site at template, and that is the right time to settle sink position, tap centres and overhang rather than agree them by email. A replacement keeps the units and changes the surface, which is the least disruptive way to do this in an occupied property. Units kept, surface changed. Tell us the building when you book and the lift, the stair turn and any freeholder notice get built into the day rather than found on it.