Worktop replacement in Rise Park

Yes. Rise Park is on the patch, and the postcodes we work here are RM1. It is worked on our east London run, along with the rest of Havering. A front drive is the best thing that can happen to a fitting day, because the tail lift comes down within a few metres of the door and nothing is on a clock. We stage the strip-out so the old tops leave in one trip rather than trickling out across the afternoon. It is a full day at the kerb, not a delivery. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

The kitchen sits at the rear with a back door beside it, so the carry is short and comes in from the garden rather than through the house. The kitchen is normally the original back room with a later side-return or rear extension bolted on, and that helps us: most pieces can go down the side alley and in through the back door in one length, so we can avoid joins that a front-door route would force. Sound carcasses are the one condition. Because the layouts repeat across the estate we can usually predict the room, but the extensions vary wildly in squareness so nothing gets cut off a drawing.

Wide, quiet roads with driveways and dropped kerbs almost throughout, plus side gates giving a clean route to the rear extension without going through the house. Garden routes carry their own hazards: a drain cover, a step up to a patio, wet decking, or a lawn that will not take a loaded trolley. With no room to turn, the old top gets cut up in the kitchen instead, which is dusty work and needs the room emptied first. The strip-out is planned around it.

It is one of the three we do most here, behind worktop installation. Same template visit, same workshop, same installers either way. Extension kitchens are usually specified long before they are buildable, so the run lengths on the drawing and the run lengths in the room are different numbers. The units stay and only the surface changes, so the whole job is one day rather than a kitchen refit. A day, not a project. Rear and side-return extensions are where the islands appear, and an island is the piece that decides whether one slab does the kitchen or two. The carcasses have to be sound, because stone is several times the weight of what is coming off. A day, not a project.

An L can be mitred at the corner for a continuous look or butt-jointed over the gable, and the two are different money and different risk. Old laminate has often been holding a run square for years, and taking it off shows what the units were really doing. Height change is checked before we cut. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Level has to hold across the whole room rather than along one wall, or a floor that falls end to end shows as a step where two pieces meet. This is the commonest reason a replacement turns out to need more than a straight swap. The laminate has been covering it up. Unlock the side gate and clear the alley of bins, bikes and pots, and arrange a plumber for the sink and an electrician if the hob is hard-wired. The householder is normally on site at template, and that is the right time to settle sink position, tap centres and overhang rather than agree them by email. A plumber disconnects before we arrive and reconnects after we leave, and that is worth booking early. Sound carcasses are the condition.