Worktop templating in Ruislip Gardens

Yes. Ruislip Gardens is on the patch, and the postcodes we work here are HA4. It is worked on our west London run, along with the rest of Hillingdon. A front drive is the best thing that can happen to a fitting day, because the tail lift comes down within a few metres of the door and nothing is on a clock. The templating visit needs somewhere to stop for two or three hours, which is a different problem from unloading for twenty minutes. It goes on the job sheet for the fitting crew. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

There is usually a shared rear alley, and whether the gate onto it is unlocked decides whether long pieces come in from the back. The typical 1930s kitchen sits at the back with a low window over the sink run, so the template records the exact sill height above the units to settle whether an upstand fits or the stone has to die into a window board. Recorded as it is, not as it was drawn. Freestanding appliance bays split the run, so what looks like one wall of worktop is actually three separate pieces with two exposed ends to polish.

Quiet residential streets off West End Road with drives on most houses. RAF Northolt and the Central line depot cut off some of the obvious through routes. Where the van stands level with the front of the house a piece gets handled twice instead of five times, and stone breaks on handling rather than on the road. A template taken without walking the route produces a drawing that cuts beautifully and will not go in. It goes on the drawing with the run dimensions.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop replacement, worktop installation and worktop fabrication. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. Rear and side-return extensions are where the islands appear, and an island is the piece that decides whether one slab does the kitchen or two. Two to three hours on site, with the sink, tap and hob physically present. Appliances on site, not on order. A new extension slab is not automatically level, and that wants checking before templating rather than after the stone is cut. The template visit is booked once the units are genuinely in, not when they are nearly in. The room as it is, not as it was drawn.

Two parallel runs with a walkway between them is the most efficient shape there is on a slab, because both pieces nest as straight lengths with almost no waste. A layout templated off one wall instead of one datum will not sit right once all the pieces are down together. The drawing leaves site complete. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Where a breast interrupts a long wall the join can often go there, so it reads as a natural break rather than a line in the middle of a worktop. It is recorded on the drawing with the run dimensions so the workshop is not guessing. Measured at worktop height, nowhere else. All base units in, including anything standing on the later extension slab, walls skimmed to final thickness, and the sink, tap and hob delivered so cut-outs and tap centres are set from the actual items. Where someone is living in the house through the work, the strip-out and the fit are planned so the kitchen is out of use for a day and not a week. A template booked hopefully around another trade is the commonest cause of a wasted visit. No stone is cut from a plan.