Worktop installation in South Croydon

Yes. South Croydon is on the patch, and the postcodes we work here are CR2. It is worked on our south London run, along with the rest of Croydon. Permit hours are what matters, not the permit itself, because a bay that frees up at six in the evening is no use for a template at ten. A van that has to move mid-fit costs the best part of an hour and takes a man off the tools to do it. It is why the arrival time is what it is. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

A range sitting in a chimney recess is common, and the flanking pieces are cut with the manufacturer clearance built into the template. What costs time is the distance from where the van can park to the door, often down a long drive or across gravel, so we plan the carry with enough hands and board the route where it crosses gravel or lawn. Walked, measured, protected, then lifted. Fitting a run against a chimney breast in a converted reception room means two returns and two scribes on one piece, which takes longer to template than a straight wall twice the length.

Brighton Road is a main bus route with limited stopping, and the side roads run steeply uphill with permit bays. Converted flats have communal front doors and original staircases. A walk-up with winders at every half-landing means the piece is rested and re-gripped on the way, so the crew size goes up before the piece size comes down. The fitting day is planned backwards from that point, before anything comes off the van. It gets checked before the first piece is lifted.

It is one of the three we do most here, behind worktop templating. Same template visit, same workshop, same installers either way. Party-wall and lease conditions in a converted building set when noisy work can happen, which shapes the fitting day more than the kitchen does. One visit, with the sink and hob seated and sealed before we leave. One visit, done properly. A kitchen carved out of a larger room sits under whatever the original plan left behind, so the run frequently ends at a blocked doorway or a boxed-in service. The fitting day is scheduled to suit that rather than to suit the diary. Sealed before we leave.

Two parallel runs with a walkway between them is the most efficient shape there is on a slab, because both pieces nest as straight lengths with almost no waste. On the day that means dry-laying the whole layout first and only then pulling and bonding the joins. Dry-lay first, always. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Alcove pieces get cut oversize on both scribe edges, with the true wall angles carried on the template drawing rather than assumed. On the day it means dry-laying, marking, and cutting the scribe on site before anything is bonded. It is the slow part of the day and it should be. Give us the hardest, shortest approach to the door you can, clear of parked cars, and warn us of any soft ground, steps or gravel on the route. An owner living in the house makes the decisions and lives with them, so the specification tends to go towards the material rather than towards the lowest total. Floors and units are protected before anything comes through the door, communal or otherwise. One visit, our own installers.