Splashbacks and upstands in South Hackney

Yes. South Hackney is on the patch, and the postcodes we work here are E9. It is worked on our east London run, along with the rest of Hackney. Without a bay the van ends up on a single yellow with a crew member watching it, which takes a pair of hands off the carry. Splashbacks are normally the last thing off, so a short parking window is exactly when they get rushed. One trip is always better than three. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

A villa cut into flats leaves kitchens in rooms that were never kitchens, with services run to wherever they could physically be made to reach. A 100mm upstand bedded on silicone is the honest answer where the plaster bows, because it rides what a tall panel exposes. The wall makes that decision, not the brochure. Where a rear alley gate exists it is the better route in, but the alleys are uneven and shared, so check the surface before committing to wheeling anything down one.

Streets are permit-only with filtered junctions and Victoria Park Road carries traffic with limited stopping. Terrace halls are narrow with the stair close to the door, though some streets have back gates onto rear alleys. Rear access usually lets us fit longer pieces whole, so the join count ends up decided by the slab rather than by the building. Splashback panels are lighter than a worktop and far more awkward, because a tall thin piece has to be carried on edge and cannot be tilted to clear a turn. That is agreed at template, not on fitting day.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop replacement, worktop templating and worktop installation. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. A kitchen carved out of a larger room sits under whatever the original plan left behind, so the run frequently ends at a blocked doorway or a boxed-in service. Ordered later from a different batch, the match is not reliable exactly where the pieces meet. Sockets final before template. Conversions put kitchens where the services could be made to reach rather than where they belong, so runs are short and interrupted. Splashbacks and upstands are cut from the same slab run at the same time, which is the only way the batch actually matches. Same batch, same run, same day.

Two runs meeting at an internal corner is the most common shape we fit, and the corner is where the decisions are. The same shape decides where splashback pieces break, and a joint in a corner reads as a detail while one in a clear run reads as a mistake. Corners get their own pieces. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A run can measure dead right at both ends and still belly out in the middle, which only appears once the template plots the intermediate points. It is usually what pushes a job towards a 100mm upstand instead of a full-height panel, because an upstand rides what a panel exposes. Make the wall good first, or accept the detail. The chimney breast recess must be replastered and fully dry, and the hob and extractor positions fixed, before anyone templates a full-height piece into it. Where a landlord or housing provider is involved there is a specification to meet and a process to follow, and both are settled before a date is offered. Full-height panels need the wall made good first, which is another trade and another timescale. Decided before fabrication, not after.