Worktop replacement in South Hampstead

Yes. South Hampstead is on the patch, and the postcodes we work here are NW6, NW3. It is worked on our central and north London run, along with the rest of Camden. Permit hours are what matters, not the permit itself, because a bay that frees up at six in the evening is no use for a template at ten. Waste is the part people forget: the old laminate or tired granite has to be walked back to the van and it does not get lighter. It is a full day at the kerb, not a delivery. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

A large villa has wide doors, a generous hall and somewhere to park, so the joins that go in are chosen for layout rather than forced by the route. These are the multi-piece jobs: long runs, a large island and often a range cooker that cannot be moved, so the stone is templated in several pieces and how the vein runs across the joins matters. Sound carcasses are the one condition. Winder stairs are worse than narrow ones for slab work because the effective diagonal shrinks at the turn, so size pieces off the tightest tread rather than the landing.

Permit bays fill early and many villas sit back behind long front paths, so the carry is 15-25 metres before you even reach the door. No lifts in the conversions, and the original staircases are generous in width but have winders at the turn. Communal stairs get boarded and the handrail padded, and we walk the route with a tape before the first piece leaves the van. With no room to turn, the old top gets cut up in the kitchen instead, which is dusty work and needs the room emptied first. That is agreed before a plumber is booked.

Yes. On the research for this patch it is the first of the three jobs listed, ahead of worktop templating and worktop installation. A kitchen carved out of a larger room sits under whatever the original plan left behind, so the run frequently ends at a blocked doorway or a boxed-in service. Old tops out in the morning, new stone down and sealed the same afternoon. A day, not a project. Conversions put kitchens where the services could be made to reach rather than where they belong, so runs are short and interrupted. The units stay and only the surface changes, so the whole job is one day rather than a kitchen refit. A day, not a project.

The catch with a galley is that both runs are seen end-on from the doorway, so any difference in overhang between the two reads immediately. Going from a 38mm laminate to 20mm or 30mm stone drops the surface, which shows against tiles, a window board and any freestanding appliance. The units stay, the surface changes. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Where a breast interrupts a long wall the join can often go there, so it reads as a natural break rather than a line in the middle of a worktop. This is the commonest reason a replacement turns out to need more than a straight swap. It is the usual surprise, and it is a known one. Have a fitter or joiner fix and level the island units beforehand, and get the sink, taps, hob and any range on site before templating so we cut to the actual appliances. Where someone is living in the house through the work, the strip-out and the fit are planned so the kitchen is out of use for a day and not a week. If the carcasses are tired the honest answer is that stone will find that out, and it is better said before than after. Plumber either side of us.