Worktop templating in Spitalfields

Yes. Spitalfields is on the patch, and the postcodes we work here are E1. It is worked on our east London run, along with the rest of Tower Hamlets. Loading exemptions on red routes are narrow, time-limited and heavily camera-enforced, so we plan around them rather than relying on them. A templater circling for a space arrives late into a slot that was already tight, and the drawing is what suffers. It goes on the job sheet for the fitting crew. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Georgian houses put the kitchen in a basement or a rear closet wing, and the stairs down to it are the tightest part of the whole route. The template plots the bow along the back of the run, which is why a tape reading taken beforehand never matches. Two to three hours, once the units are in. You cannot cut a listed house to suit the stone, so the stone gets templated and jointed to suit the house, including a joint mid-run just to get it down the stairs.

Most of the area is a conservation area with a high concentration of listed houses, so any fixings into original fabric and any external hoisting need consent and a careful method. Streets are narrow, largely pedestrianised near the market and loading windows are early morning only, with staircases inside the houses that are steep, winding and original. A hoisted piece needs a clear drop zone, a lifting plan and someone stationed at street level, none of which gets arranged on the morning. Door widths, turn diagonals and any change of level are recorded on the drawing alongside the run dimensions. The template records it along with everything else.

Yes. On the research for this patch it is the first of the three jobs listed, ahead of worktop fabrication and worktop design & quotation. Conversions put kitchens where the services could be made to reach rather than where they belong, so runs are short and interrupted. No stone is ever cut from a plan, which is inconvenient exactly when a programme is tight. The room as it is, not as it was drawn.

The catch with a galley is that both runs are seen end-on from the doorway, so any difference in overhang between the two reads immediately. Join positions and vein direction are marked on the template drawing before it leaves site. One datum for the whole room. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Where a corner is a couple of degrees off, a mitre cut to a theoretical ninety degrees opens on the wall side and there is no closing it afterwards. The template plots it as it is, at the exact height the worktop will sit, and the drawing carries that through. Measured at worktop height, nowhere else. Units fixed and packed level over the sloping floor, walls replastered and dry at their final thickness (tiling and splashbacks go on after the worktop, never before), and the sink, tap and hob physically on site, with a Belfast sink built in and set at its finished height. A street with houses in single occupation next to the same houses cut into flats produces two completely different jobs from the same elevation. A template booked hopefully around another trade is the commonest cause of a wasted visit. No stone is cut from a plan.