Kitchen worktops in St Quintin Park

Yes. The St Quintin streets are later and lower density than the stucco to the south, so kitchens are ground floor at the rear with a side return that has usually been infilled to give an L of about 3.4m plus 2.2m, and bifolds onto a proper garden. Because the ground floor is level with the garden rather than sunk, appliances and worktops go straight in through the back rather than round the front. A free-parking street with cars both sides can still leave the van forty metres away, and that distance is carry, not driving. It rarely changes what we cut, but it does change how the pieces are stacked and strapped for the run out. The load plan follows from it.

Edwardian estate terrace, Arts and Crafts influenced semi, interwar cottage housing and small modern infill. Where the side return has been filled in, the old external wall is now an internal one and still carries its render, its gutter line and its old fixings. Alcoves either side of the breast are rarely the same width and rarely parallel, so each one is templated as its own piece with its own scribe. No stone is ever cut from a plan.

Wider streets and front gardens mean you can generally get a van reasonably close, but the front paths have steps and low gate posts and the side alleys between houses are frequently under 800mm clear. If the rear route is on, use it; if not, everything goes down a hallway with a stair spindle at the far end. Garden routes carry their own hazards: a drain cover, a step up to a patio, wet decking, or a lawn that will not take a loaded trolley. The templater measures that route on the same visit, so the drawing leaves site already knowing the maximum piece. It goes on the drawing with the run dimensions.

Worktop templating, worktop fabrication and worktop installation, in that order. Rear and side-return extensions are where the islands appear, and an island is the piece that decides whether one slab does the kitchen or two. So the nesting is planned around it rather than around a standard kitchen. Same slab run, or it is not a match. Check the side alley clear width at template - an 800mm gap will not pass a 900mm deep island top no matter how it is angled.

An L can be mitred at the corner for a continuous look or butt-jointed over the gable, and the two are different money and different risk. The template records every angle in that shape as it actually is rather than as the plan drew it. One datum for the whole room. Floors settle, and once base units are packed and levelled properly the stone sits true while everything else in the room admits it is not. Cut it square where it should be radiused and the piece will fail on the lift, not in the kitchen. Radiused, polished, and clear of the joins. Material runs from £110 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines rather than rolled into one figure.

Mixed ownership means the decision-maker is not always the person who lets us in, so it is worth being clear early about who signs the quote off. The workshop works from the approved drawing, so whoever signs it off is signing off the join positions too. Dry-assembled before it leaves. Tell us the building when you book and the lift, the stair turn and any freeholder notice get built into the day rather than found on it.