Worktop templating in St Quintin Park

Yes. St Quintin Park is on the patch, and the postcodes we work here are W10. It is worked on our west London run, along with the rest of Kensington and Chelsea. Unrestricted kerbside is straightforward as long as the space in front of the property is actually clear when the van arrives. It is noted on the job sheet at template so the fitting crew inherit the answer rather than rediscovering it. It goes on the job sheet for the fitting crew. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

The back addition is a narrow two-storey outrigger with a single external wall, and the kitchen galley runs the length of it. The template plots the bow along the back of the run, which is why a tape reading taken beforehand never matches. No stone is ever cut from a plan. Check the side alley clear width at template - an 800mm gap will not pass a 900mm deep island top no matter how it is angled.

Wider streets and front gardens mean you can generally get a van reasonably close, but the front paths have steps and low gate posts and the side alleys between houses are frequently under 800mm clear. If the rear route is on, use it; if not, everything goes down a hallway with a stair spindle at the far end. A side gate and a back door mean the stone never goes through the house at all, which keeps the dust and most of the risk outside. The templater measures that route on the same visit, so the drawing leaves site already knowing the maximum piece. The template records it along with everything else.

Yes. On the research for this patch it is the first of the three jobs listed, ahead of worktop fabrication and worktop installation.

Two runs meeting at an internal corner is the most common shape we fit, and the corner is where the decisions are. A layout templated off one wall instead of one datum will not sit right once all the pieces are down together. The drawing leaves site complete. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Legs bottoming out on hard concrete or an uneven screed mean the tops of the carcasses are not one plane, and that is picked up at template rather than on fitting day. One measurement never describes it, which is why a tape reading taken before the visit rarely matches the template. That is why the visit takes two or three hours. Units fixed and packed level over the sloping floor, walls replastered and dry at their final thickness (tiling and splashbacks go on after the worktop, never before), and the sink, tap and hob physically on site, with a Belfast sink built in and set at its finished height. Mixed ownership means the decision-maker is not always the person who lets us in, so it is worth being clear early about who signs the quote off. The templater needs the sink, tap and hob on site, and a Belfast sink installed at its final height. No stone is cut from a plan.