Worktop templating in Golborne

Yes. Golborne is on the patch, and the postcodes we work here are W10. It is worked on our west London run, along with the rest of Kensington and Chelsea. Where an event closes the road entirely, the van cannot be moved once it is in, which is a different problem from not being able to park at all. It is noted on the job sheet at template so the fitting crew inherit the answer rather than rediscovering it. The templater needs a proper stop, not a pause. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Edwardian terraces are wider and taller than the Victorian houses next to them, so the kitchen usually takes a full-width rear room rather than a narrow outrigger. Alcoves either side of the breast are rarely the same width and rarely parallel, so each one is templated as its own piece with its own scribe. Two to three hours, once the units are in. In a listed block, keep the alteration to like-for-like surface work - move a duct or a wall and the job stops while consent is chased.

Golborne Road has market trading days that close kerbside access, so deliveries are better before the stalls go up. The tower is served by a single lift core off a ground-floor lobby with a long approach walk, and residential flats sit on the far side of an access bridge from the lift landing, which means everything is hand-carried the last stretch. Piece length is set by the internal diagonal of the lift car, not by the length of the slab. Door widths, turn diagonals and any change of level are recorded on the drawing alongside the run dimensions. That is part of what the visit is for.

It is one of the three we do most here, behind worktop replacement. Same template visit, same workshop, same installers either way. Extension kitchens are usually specified long before they are buildable, so the run lengths on the drawing and the run lengths in the room are different numbers. No stone is ever cut from a plan, which is inconvenient exactly when a programme is tight. The room as it is, not as it was drawn.

A galley run down a side-return extension usually measures longer than a slab will give in one length, so a join is designed in from the start rather than discovered. Join positions and vein direction are marked on the template drawing before it leaves site. The drawing leaves site complete. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A boxed soil stack or service riser in the corner of a run eats into the worktop depth and has to be scribed around rather than cut square. It is recorded on the drawing with the run dimensions so the workshop is not guessing. Measured at worktop height, nowhere else. Units fixed and packed level over the sloping floor, walls replastered and dry at their final thickness (tiling and splashbacks go on after the worktop, never before), and the sink, tap and hob physically on site, with a Belfast sink built in and set at its finished height. Where ownership is split across a building, the common parts belong to someone else and the carry route is negotiated rather than assumed. The template happens when the units are in, fixed and level, whoever is fitting them. Fitted, fixed and level, then we come.