Kitchen worktops in Tooting Graveney

Yes. More interwar semis than the north end of Tooting, so the recurring job is knocking the kitchen into the rear reception and running an L with a breakfast bar rather than building a big glass box. Runs sit around 3m with a 1.5m return. A drive that shelves towards the house needs the van chocked and the trolley controlled, since a loaded A-frame gathers speed quickly on a slope. The templating visit needs somewhere to stop for two or three hours, which is a different problem from unloading for twenty minutes. The templater needs a proper stop, not a pause.

Interwar semi, Victorian terrace and 1960s low-rise flat. There is usually a shared rear alley, and whether the gate onto it is unlocked decides whether long pieces come in from the back. The kitchen is normally the original back room with a later side-return or rear extension bolted on, and that helps us: most pieces can go down the side alley and in through the back door in one length, so we can avoid joins that a front-door route would force. What is under the old top is the real question.

Parking restrictions are lighter towards the borough boundary and many houses have hardstanding, which makes staging easier than in central Tooting. Side alleys between semis are the usual squeeze at roughly 800mm. The side passage is the measurement that matters, because a piece has to be carried flat down it and then turned in at the back door, and the turn is always tighter than the passage. Worth remembering that the old tops have to come out the way the new ones come in, and a laminate run is easier to remove in one length than to carry in one. It sets what the day actually looks like.

Worktop installation, worktop replacement and worktop templating, in that order. Extension kitchens are usually specified long before they are buildable, so the run lengths on the drawing and the run lengths in the room are different numbers. The carcasses have to be sound, because stone is several times the weight of what is coming off. A day, not a project. Knocking into the rear reception leaves the old external wall thickness as a step in the run, so the worktop needs a stepped back edge rather than a straight scribe.

The return piece is the awkward one on a slab: short, full depth, and rarely nesting neatly against the long lengths, so yield rather than area is what moves the material figure. On the day that means dry-laying the whole layout first and only then pulling and bonding the joins. Dry-lay first, always. A run can measure dead right at both ends and still belly out in the middle, which only appears once the template plots the intermediate points. On the day it means dry-laying, marking, and cutting the scribe on site before anything is bonded. Dry-lay, mark, cut, then bond. Material runs from £110 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines rather than rolled into one figure.

Owner-occupied kitchens are usually being done once, which is why the edge profile, the vein direction and where a join falls are worth the conversation. A replacement keeps the units and changes the surface, which is the least disruptive way to do this in an occupied property. Units kept, surface changed. Tell us the building when you book and the lift, the stair turn and any freeholder notice get built into the day rather than found on it.