Kitchen worktops in Upney

Yes. Inter-war semis and terraces on the edge of the Becontree layout, where kitchens are small but the plots are deep enough for a shallow rear extension, and most jobs end with an L-shape of about 3m by 1.8m plus a utility by the back door. Units are commonly replaced at the same time as the tops because the originals are past saving. A drive that shelves towards the house needs the van chocked and the trolley controlled, since a loaded A-frame gathers speed quickly on a slope. The templating visit needs somewhere to stop for two or three hours, which is a different problem from unloading for twenty minutes. The templater needs a proper stop, not a pause.

1930s semi, inter-war terrace and post-war infill. A side alley and a back door mean most pieces go in whole, and it is the alley width rather than the front door that decides it. What catches people out is the junction between the old floor and the extension floor, which is rarely at the same level, so a run carrying across it needs the units packed before stone goes on. What is under the old top is the real question.

Regular suburban streets with a mix of dropped kerbs and kerbside parking, and a side alley between most pairs of semis giving a route to the back garden. Rear access usually lets us fit longer pieces whole, so the join count ends up decided by the slab rather than by the building. With no room to turn, the old top gets cut up in the kitchen instead, which is dusty work and needs the room emptied first. It sets what the day actually looks like.

Worktop installation, worktop replacement and worktop templating, in that order. Extension kitchens are usually specified long before they are buildable, so the run lengths on the drawing and the run lengths in the room are different numbers. The units stay and only the surface changes, so the whole job is one day rather than a kitchen refit. A day, not a project. Deep plots mean the kitchen is a long way from the van, so we plan the carry and clear the side alley of bins before the slab comes off the vehicle.

An L can be mitred at the corner for a continuous look or butt-jointed over the gable, and the two are different money and different risk. A layout that has been packed and levelled run by run instead of to one datum shows as a step where two pieces meet. Dry-lay first, always. A chimney breast left in place splits a wall into two alcoves, and the two are rarely the same width and rarely parallel to each other. This is the commonest reason a replacement turns out to need more than a straight swap. Found at template, not on fit day. Material runs from £110 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines rather than rolled into one figure.

Owner-occupied kitchens are usually being done once, which is why the edge profile, the vein direction and where a join falls are worth the conversation. A replacement keeps the units and changes the surface, which is the least disruptive way to do this in an occupied property. Units kept, surface changed. Tell us the building when you book and the lift, the stair turn and any freeholder notice get built into the day rather than found on it.