Kitchen worktops in Castle Green

Yes. Housing squeezed between the A13 and the Becontree layout, mostly inter-war and post-war family homes with small original kitchens, plus newer regeneration housing coming forward. The typical job is combining kitchen and dining room and running a continuous top across the old wall line so the space reads as one room. A front drive is the best thing that can happen to a fitting day, because the tail lift comes down within a few metres of the door and nothing is on a clock. A replacement is a two-way job, with old tops going out and new stone coming in, so the van needs to stay put across the whole day. Old tops out and new stone in, both through the same gap.

1930s Becontree-era house, post-war housing and regeneration new-build. An inter-war terrace is wider than a Victorian one and shallower than a semi, so the kitchen is a compact square room rather than a galley. Access is usually the easy part here, as most of these have a side gate and a back door straight into the kitchen, so we carry down the side alley rather than through the house and keep the mess outside. Walked, measured, protected, then lifted.

Reasonable residential streets but bounded by major roads, so route planning matters more than parking; most houses have some frontage to pull onto. A short hard approach with no steps means a full-length piece can be walked in flat by two people rather than turned up on edge. The fitting day is planned backwards from that point, before anything comes off the van. That is what the morning is planned around.

Worktop installation, worktop replacement and worktop templating, in that order. Rear and side-return extensions are where the islands appear, and an island is the piece that decides whether one slab does the kitchen or two. Where the window is fixed there is no second day to fall back on, so the prep list matters more than usual. One visit, done properly. When we run a top across a removed wall line the two floor levels rarely match, so the base units get levelled to a datum line, not to the floor.

Galley runs are usually short enough to come out of a single slab, so the material band you choose does more to the total than the room shape does. The template records every angle in that shape as it actually is rather than as the plan drew it. One datum for the whole room. Floors settle, and once base units are packed and levelled properly the stone sits true while everything else in the room admits it is not. The old top has been hiding it, so the first honest look at it happens when the laminate comes off. Found at template, not on fit day. Material runs from £110 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines rather than rolled into one figure.

Owner-occupied kitchens are usually being done once, which is why the edge profile, the vein direction and where a join falls are worth the conversation. The fitting day is arranged with whoever can actually give us access for the whole slot. Protection goes down first. Tell us the building when you book and the lift, the stair turn and any freeholder notice get built into the day rather than found on it.