Kitchen worktops in Walworth

Yes. Small Georgian and early Victorian terraces around the squares where a rear closet-wing kitchen gives an L of about 2.4m by 1.4m, and Victorian artisan tenements where the flats were never designed for a modern kitchen at all, so units are shoehorned in around windows and stacks. A red route means no stopping, and no stopping means exactly that, so the stone comes in from a side street or from a bay behind the property. The templating visit needs somewhere to stop for two or three hours, which is a different problem from unloading for twenty minutes. The templater needs a proper stop, not a pause.

Georgian square terrace, Victorian tenement block, Victorian terrace and 1930s and 1960s estate. A small room puts the sink, hob and tap cut-outs close together on one short length, and the bridge of stone left between them decides whether it can be cut in one piece. We measure the front door, the hall width and the turn into the kitchen before anything comes off the van, because a 3m piece has to swing through that corner on edge and stone does not bend to help you. Walked, measured, protected, then lifted.

The tenement blocks are reached by external stairs and shared landings with a tight 180-degree turn and no lift; Walworth Road is a red route with heavy bus traffic, so loading has to happen on the residential side streets. Stone goes up on edge, and it is the half-landing turn rather than the flight itself that sets the maximum piece. Finding it out on the morning costs the whole slot, because there is no second route to fall back on. That is what the morning is planned around.

Worktop replacement, worktop templating and worktop installation, in that order. Extension kitchens are usually specified long before they are buildable, so the run lengths on the drawing and the run lengths in the room are different numbers. The fitting day is scheduled to suit that rather than to suit the diary. One visit, done properly. The tenement stairs decide the piece sizes - anything over about 2m on edge will not make the turn, so joints get placed to suit the stairwell.

Where the return runs into a wall that is out of square, the corner is templated as the angle it really is rather than as ninety degrees. The template records every angle in that shape as it actually is rather than as the plan drew it. One datum for the whole room. Anything that has to stay accessible, a stopcock, a gas meter, a riser panel, is marked on the template so the stone is cut around it instead of over it. On the day it means dry-laying, marking, and cutting the scribe on site before anything is bonded. Dry-lay, mark, cut, then bond. Material runs from £110 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines rather than rolled into one figure.

Where ownership is split across a building, the common parts belong to someone else and the carry route is negotiated rather than assumed. A half-day of access is not a fitting day, and it is better to say so at booking than to find out at eleven. Access for the whole slot, or a different day. Tell us the building when you book and the lift, the stair turn and any freeholder notice get built into the day rather than found on it.