Splashbacks and upstands in West Drayton

Yes. West Drayton is on the patch, and the postcodes we work here are UB7. It is worked on our west London run, along with the rest of Hillingdon. Where the frontage is a clearway the unload happens away from the door and the carry gets longer, which is a crew and time question rather than a stone one. Upstands travel in a crate and can wait on the van, which gives some flexibility a full-height panel does not. One trip is always better than three. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

These kitchens have been retiled at least twice, and stripping the tiles takes the bottom band of plaster with them because the old laminate ran underneath rather than up to them. These kitchens are nearly always retiled at least twice, and stripping the old tiles takes the bottom course of plaster with it because the original laminate top ran underneath the tiles rather than up to them. Decided before fabrication starts. New-build flats here come with thin compact laminate already fitted, so the upgrade usually means a new sink and tap as well as new tops.

The station area is clogged with commuter parking and the level crossing. The village streets have drives, but the new developments are built on narrow shared surfaces with limited waiting. A short hard approach with no steps means a full-length piece can be walked in flat by two people rather than turned up on edge. It is usually the full-height panels rather than the tops that will not make the turn, and that only shows up when they arrive. That is agreed at template, not on fitting day.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop replacement, worktop installation and worktop templating. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. Upgrading a builder-finish kitchen is mostly a swap, so the cost sits in the material choice rather than in the shape of the room. Ordered later from a different batch, the match is not reliable exactly where the pieces meet. Sockets final before template. Handover-spec kitchens are square, plumb and predictable, which means the join count is honest and driven by run length rather than by the building. Splashbacks and upstands are cut from the same slab run at the same time, which is the only way the batch actually matches. Siliconed to the worktop, never grouted.

Two parallel runs with a walkway between them is the most efficient shape there is on a slab, because both pieces nest as straight lengths with almost no waste. The same shape decides where splashback pieces break, and a joint in a corner reads as a detail while one in a clear run reads as a mistake. The joint to the worktop is siliconed, never grouted. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Sill height gets settled with the template on site, because it is one of the few dimensions nobody has measured before we arrive. A tall panel that fits at the worktop will stand off the wall at the top unless the wall is dubbed out or the panel is scribed. An upstand rides what a panel exposes. The old tiling must be off and the wall made good and dry before templating, not on fitting day. An owner living in the house makes the decisions and lives with them, so the specification tends to go towards the material rather than towards the lowest total. Splashbacks are cut from the same slab run as the tops, so they have to be decided before fabrication, not after. Same slab run as the tops.