Worktop replacement in Whetstone

Yes. Whetstone is on the patch, and the postcodes we work here are N20. It is worked on our north London run, along with the rest of Barnet. Loading exemptions on red routes are narrow, time-limited and heavily camera-enforced, so we plan around them rather than relying on them. A replacement is a two-way job, with old tops going out and new stone coming in, so the van needs to stay put across the whole day. The waste run is planned, not improvised. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

The original kitchen was a small service room, so what is there now is a knock-through and the junction between the two floors is rarely level. A mansion block is a logistics job before it is a stone job. What is under the old top is the real question. Retirement blocks often have restricted working hours and no drilling before nine, so a wet-cut on site is usually not an option and pieces must arrive finished.

The High Road is a red route with almost no stopping, so vans work from side streets; the flat blocks have parking courts and lifts, but many of the older ones have lifts too small for a full-length slab. The lift has to be booked and blanketed before anything moves, and that booking needs to cover the old tops coming out as well as the new stone going in. With no room to turn, the old top gets cut up in the kitchen instead, which is dusty work and needs the room emptied first. The strip-out is planned around it.

Yes. On the research for this patch it is the first of the three jobs listed, ahead of worktop installation and worktop templating. A new extension slab is not automatically level, and that wants checking before templating rather than after the stone is cut. Old tops out in the morning, new stone down and sealed the same afternoon. A day, not a project. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. The units stay and only the surface changes, so the whole job is one day rather than a kitchen refit. A day, not a project.

The catch with a galley is that both runs are seen end-on from the doorway, so any difference in overhang between the two reads immediately. Going from a 38mm laminate to 20mm or 30mm stone drops the surface, which shows against tiles, a window board and any freestanding appliance. Height change is checked before we cut. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A boxed soil stack or service riser in the corner of a run eats into the worktop depth and has to be scribed around rather than cut square. The old top has been hiding it, so the first honest look at it happens when the laminate comes off. Found at template, not on fit day. Get the managing agent's or freeholder's approval and the permitted hours confirmed beforehand, and agree with the porter who protects the communal carpet, stonework and lift. Where ownership is split across a building, the common parts belong to someone else and the carry route is negotiated rather than assumed. If the carcasses are tired the honest answer is that stone will find that out, and it is better said before than after. Units kept, surface changed.