Splashbacks and upstands in Woodside Park

Yes. Woodside Park is on the patch, and the postcodes we work here are N12. It is worked on our north London run, along with the rest of Barnet. A drive that shelves towards the house needs the van chocked and the trolley controlled, since a loaded A-frame gathers speed quickly on a slope. Upstands travel in a crate and can wait on the van, which gives some flexibility a full-height panel does not. Handling is where these pieces get damaged. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Original joinery is deep and stands proud of the plaster, so the run is plotted to the units rather than to the wall behind them. Behind a range cooker with gas burners, granite or sintered stone is the sensible pick; quartz has a resin binder and does not enjoy sustained radiant heat at close range, so keep it out of the immediate hob zone or specify a different material for that panel. Cut from the same slab run as the tops. Big islands with multiple cut-outs need lifting in one piece with at least four hands, and the floor has to be checked for level across the whole island footprint first.

Some of the best access in the borough: long driveways, wide verged roads, off-street turning space and clear side gates to the rear garden. The only obstacle is usually a mature hedge or a gate post narrowing the side route. Garden routes carry their own hazards: a drain cover, a step up to a patio, wet decking, or a lawn that will not take a loaded trolley. Splashback panels are lighter than a worktop and far more awkward, because a tall thin piece has to be carried on edge and cannot be tilted to clear a turn. It decides panel size before anything is cut.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop installation, worktop design & quotation and worktop fabrication. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. Splashbacks and upstands are cut from the same slab run at the same time, which is the only way the batch actually matches. Same batch, same run, same day. Rear and side-return extensions are where the islands appear, and an island is the piece that decides whether one slab does the kitchen or two. Socket and switch positions have to be final before templating, because a cut-out in the wrong place means a new piece. Sockets final before template.

If the island is a few hundred millimetres longer than the usable length of a slab, a second slab gets bought to gain that overhang, and the whole slab is paid for rather than the part used. Upstands follow the run exactly, so every internal and external corner is a separate mitred or butted piece. The joint to the worktop is siliconed, never grouted. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Level has to hold across the whole room rather than along one wall, or a floor that falls end to end shows as a step where two pieces meet. Where the wall cannot be made good, setting the stone deliberately proud on a subframe with a shadow gap reads as a detail rather than a bad fit. An upstand rides what a panel exposes. The range and extractor must be sited and the window cill finished before the template, as both fix the vertical limits of the splashback. An owner living in the house makes the decisions and lives with them, so the specification tends to go towards the material rather than towards the lowest total. Full-height panels need the wall made good first, which is another trade and another timescale. Decided before fabrication, not after.