Splashbacks and upstands in Mill Hill

Yes. Mill Hill is on the patch, and the postcodes we work here are NW7. It is worked on our north London run, along with the rest of Barnet. Off-street parking means the van stays put all day, so tools, packers and the offcut we would rather have than not are all within reach. Panels come off the van in one trip where possible, since a tall piece handled repeatedly is a piece asking to be chipped. Handling is where these pieces get damaged. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

A range or an Aga in an original recess is usually immovable, so the run is designed around it and the clearances come from the appliance. These runs are long and often include a range recess, so the splashback is nearly always more than one piece and the joint placement matters, put it in a corner or over a hob centre line, not randomly in the middle of a clear run. Decided before fabrication starts. Steep, narrow lanes around the village mean the material is better delivered on a smaller vehicle in two trips than on one big load that cannot turn.

The Ridgeway and the village lanes are narrow with sharp gradients and few passing places, so a large vehicle is a liability; the modern estates below have wide roads and long driveways with easy loading. Sign-in at the gate, a permit on the dash and a named contact are usually wanted before anything comes off the van. It is usually the full-height panels rather than the tops that will not make the turn, and that only shows up when they arrive. Joint positions follow from that.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop design & quotation, worktop installation and worktop fabrication. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. A new extension slab is not automatically level, and that wants checking before templating rather than after the stone is cut. Socket and switch positions have to be final before templating, because a cut-out in the wrong place means a new piece. Same batch, same run, same day. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. Splashbacks and upstands are cut from the same slab run at the same time, which is the only way the batch actually matches. Sockets final before template.

On a heavily veined stone the island and the run behind it are nested off the same area of slab so the movement relates across the room. The same shape decides where splashback pieces break, and a joint in a corner reads as a detail while one in a clear run reads as a mistake. Corners get their own pieces. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A chimney breast left in place splits a wall into two alcoves, and the two are rarely the same width and rarely parallel to each other. It is usually what pushes a job towards a 100mm upstand instead of a full-height panel, because an upstand rides what a panel exposes. Make the wall good first, or accept the detail. The range and extractor must be sited and the window cill finished before the template, as both fix the vertical limits of the splashback. The householder is normally on site at template, and that is the right time to settle sink position, tap centres and overhang rather than agree them by email. Splashbacks are cut from the same slab run as the tops, so they have to be decided before fabrication, not after. Decided before fabrication, not after.