Worktop design and quotation in Mill Hill

Yes. Mill Hill is on the patch, and the postcodes we work here are NW7. It is worked on our north London run, along with the rest of Barnet. A front drive is the best thing that can happen to a fitting day, because the tail lift comes down within a few metres of the door and nothing is on a clock. It sits in the fitting line as time on site rather than as anything to do with the stone. Nothing here is added after the fact. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

A range or an Aga in an original recess is usually immovable, so the run is designed around it and the clearances come from the appliance. If the island top is a few hundred millimetres longer than the usable length of a slab, you buy a second slab to gain that overhang, the whole slab, not the part you use, and that is a material decision worth more than any other line on the quote. Priced from the building, not from a rate card. Steep, narrow lanes around the village mean the material is better delivered on a smaller vehicle in two trips than on one big load that cannot turn.

The Ridgeway and the village lanes are narrow with sharp gradients and few passing places, so a large vehicle is a liability; the modern estates below have wide roads and long driveways with easy loading. The barrier, the entry code and the estate rules decide when a van can get near the door, and none of that is negotiable on the day. An access-driven join is priced like any other join, and people are always surprised to see one on a dead straight run. Nothing about it gets estimated after the fact.

Yes. On the research for this patch it is the first of the three jobs listed, ahead of worktop installation and worktop fabrication. Rear and side-return extensions are where the islands appear, and an island is the piece that decides whether one slab does the kitchen or two. That changes what the quote should be compared against, because the shape of the job is not the same as a single family kitchen. Material is the slab only, and it says so. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. Comparing quotes only works when they itemise the same things, and this is where the differences usually hide. Itemised, so it can be compared honestly.

Seating overhangs past roughly 300mm will not carry on the carcass alone, so flat steel bar or a plywood substrate has to be built into the units first. It is the shape rather than the square metreage that moves the number, which is why two kitchens the same size quote differently. Shape first, area second. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A chimney breast left in place splits a wall into two alcoves, and the two are rarely the same width and rarely parallel to each other. Send photographs of every corner of the room and it gets priced properly first time. Priced as fabrication, not as area. Send the island size including the overhang and which side people sit at, the stool count, and confirm the edge profile you want and which edges are to receive it. Owner-occupied kitchens are usually being done once, which is why the edge profile, the vein direction and where a join falls are worth the conversation. The quote is written so it can be read by whoever is paying rather than only by whoever is standing in the kitchen. Written to be read by whoever is paying.