Worktop fabrication in Woodside

Yes. Woodside is on the patch, and the postcodes we work here are SE25. It is worked on our south London run, along with the rest of Croydon. A free-parking street with cars both sides can still leave the van forty metres away, and that distance is carry, not driving. It rarely changes what we cut, but it does change how the pieces are stacked and strapped for the run out. The load plan follows from it. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Walls are dense block or in-situ concrete with a bonded plaster, so the bottom course of tiles brings plaster with it when the old top comes off. Walls in the system-built blocks are concrete or panel and can bow noticeably over the length of a run, so the template picks up the real line and we cut the back edge to follow it rather than trimming on site with a grinder. The bench proves it before the van moves. Blocked-up serving hatches leave a fresh plaster patch behind the run, so we template after it has been made good, not while it is still a hole.

Tram tracks run through the area and the roads either side are narrow with restricted stopping, while the estate blocks have shared entrance doors and stairwells with a half-landing. Communal stairs get boarded and the handrail padded, and we walk the route with a tape before the first piece leaves the van. Getting that wrong leaves a finished, machined piece that cannot reach the room, which is a remake rather than a trim. The drawing carries that decision through to the saw.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop replacement, worktop splashbacks & upstands and worktop installation. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. Landlord work is scheduled around void periods, so the whole thing is a fixed window and the template date matters as much as the fitting date. Pieces are dry-assembled and checked on the bench before anything is loaded. Same slab run, or it is not a match. A worktop replacement between tenancies is a single-day job by design, because the flat is not earning while it is empty. So the nesting is planned around it rather than around a standard kitchen. Nested for the job in front of us.

A peninsula is an island with one end tied to a run, which means the join between them has to be planned rather than allowed to happen. The nest is laid out around that, with joins placed over cabinet gables and kept clear of every cut-out. That is nested before any glass goes on the saw. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Anything that has to stay accessible, a stopcock, a gas meter, a riser panel, is marked on the template so the stone is cut around it instead of over it. Cut it square where it should be radiused and the piece will fail on the lift, not in the kitchen. Radiused, polished, and clear of the joins. The stack boxing needs to be in its final form and the sink and hob on site before we machine, since a boxing that gets re-clad afterwards throws the notch out. These kitchens tend to be compact and reasonably square, so the fixed template, fabrication and fitting lines are a larger share of the total than the stone is. Sink and hob are dry-fitted on the bench before dispatch, whoever supplied them. Dry-assembled before it leaves.