Worktop fabrication in Ashburton

Yes. Ashburton is on the patch, and the postcodes we work here are CR0. It is worked on our south London run, along with the rest of Croydon. On a street with no restrictions the constraint is other residents rather than a warden, so it is worth putting a cone or a car out early. Pieces are loaded in reverse fitting order so the first thing off the van is the first thing that goes down. The load plan follows from it. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Original quarry-tiled floors sit lower than a later screed, so a run crossing that junction needs the units packed to one level. What does drive the bench work is the knocked-through kitchen-diner: the return worktop and any peninsula are seen end-on from the dining side, so we nest the pieces so the veining carries across the internal corner in the same direction rather than turning through ninety degrees. The bench proves it before the van moves. Reusing existing carcasses means the old laminate has to come off without wrecking the units, and any belfast sink or overhanging hob needs the cabinet rails checked for level first.

Wide roads with verges and unrestricted parking, so the van gets close; most houses have a short concrete path and a low front wall rather than a drive. Door width, hall width and the diagonal at the turn are three separate measurements, and it is the diagonal that catches people out. Getting that wrong leaves a finished, machined piece that cannot reach the room, which is a remake rather than a trim. It is settled on the bench, not on site.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop replacement, worktop installation and worktop splashbacks & upstands. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. Rear and side-return extensions are where the islands appear, and an island is the piece that decides whether one slab does the kitchen or two. Cutting several kitchens from different slabs and calling them matched is where firms get caught out. Same slab run, or it is not a match. A new extension slab is not automatically level, and that wants checking before templating rather than after the stone is cut. Pieces are dry-assembled and checked on the bench before anything is loaded. Nested for the job in front of us.

The catch with a galley is that both runs are seen end-on from the doorway, so any difference in overhang between the two reads immediately. A join that lands in the wrong place cannot be moved once the cut-outs are machined, so it is settled on the drawing. That is nested before any glass goes on the saw. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Legs bottoming out on hard concrete or an uneven screed mean the tops of the carcasses are not one plane, and that is picked up at template rather than on fitting day. Cut it square where it should be radiused and the piece will fail on the lift, not in the kitchen. The drawing decides it, not the fitter. The peninsula end detail needs deciding up front - square edge, mitred apron down the end, or a full waterfall - because a waterfall end has to be cut in sequence off the same part of the slab as the top. Where a landlord or housing provider is involved there is a specification to meet and a process to follow, and both are settled before a date is offered. Changing an appliance after the nest is set means recutting the piece, not adjusting it. Dry-assembled before it leaves.