Worktop replacement in World's End

Yes. World's End is on the patch, and the postcodes we work here are SW10. It is worked on our west London run, along with the rest of Kensington and Chelsea. On a street with no restrictions the constraint is other residents rather than a warden, so it is worth putting a cone or a car out early. Waste is the part people forget: the old laminate or tired granite has to be walked back to the van and it does not get lighter. Old tops out and new stone in, both through the same gap. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Deck access means a long open walkway from the lift or the stair to the front door, and that walk happens with the piece on edge in whatever weather there is. Plaster bonded straight onto concrete comes away with the bottom course of tiles, leaving a band behind the upstand. What is under the old top is the real question. Repeatable layouts but a brutal carry - the podium walk plus a shallow lift car is why pieces here get jointed at the hob even when they would technically fit the kitchen.

Vehicles cannot get to most front doors - you park at a designated bay and cross a raised podium and covered walkways on foot, then take a lift that serves several levels of deck. The lifts are narrow with a shallow car depth, so slabs go in on edge and anything over about 2.4m needs the stair, and the stairs are dog-leg concrete with steel handrails at shoulder height. Piece length is set by the internal diagonal of the lift car, not by the length of the slab. We plan the strip-out and the carry as one movement so the kitchen is only out of use for a single day. The strip-out is planned around it.

Yes. On the research for this patch it is the first of the three jobs listed, ahead of worktop installation and worktop splashbacks & upstands. Landlord work is scheduled around void periods, so the whole thing is a fixed window and the template date matters as much as the fitting date. The units stay and only the surface changes, so the whole job is one day rather than a kitchen refit. A day, not a project. A worktop replacement between tenancies is a single-day job by design, because the flat is not earning while it is empty. Old tops out in the morning, new stone down and sealed the same afternoon. A day, not a project.

A galley puts the sink on one side and the hob on the other, which spreads the cut-outs across two pieces instead of weakening one. Going from a 38mm laminate to 20mm or 30mm stone drops the surface, which shows against tiles, a window board and any freestanding appliance. The units stay, the surface changes. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

An intruding steel column, a brick pier or a downstand breaks a run that would otherwise have been one clean piece. This is the commonest reason a replacement turns out to need more than a straight swap. The laminate has been covering it up. Sort a parking bay or permit near the entrance, confirm the lift is in service and get us the door codes, and tell us about any asbestos survey on the flat before we start stripping out. Consent for the work sits with the freeholder or the managing body, and getting it in writing first avoids a crew arriving to a locked door. If the carcasses are tired the honest answer is that stone will find that out, and it is better said before than after. Units kept, surface changed.