Kitchen worktops in Addington

Yes. The village core has small period cottages with tight kitchens and low ceilings, while the surrounding 1960s-70s detached houses have square kitchens with integral garages behind, commonly converted into a utility with a second worktop run. A drive that shelves towards the house needs the van chocked and the trolley controlled, since a loaded A-frame gathers speed quickly on a slope. A replacement is a two-way job, with old tops going out and new stone coming in, so the van needs to stay put across the whole day. Old tops out and new stone in, both through the same gap.

old village cottage, 1960s detached, 1970s detached and modern executive housing. Base units from the seventies and eighties are often only 500mm deep, so a 600mm stone top overhangs at the front and the doors want checking against it. Runs are short, joins are few and the biggest single question is whether we can go in through the back, a rear door straight from the garden into the kitchen usually lets us fit long pieces whole, whereas a mid-terrace with no side gate means everything comes through the front and may need splitting. That is what the itemised lines are for.

The village lanes are narrow with a sharp bend and no pavement in places, and the tram runs through on its own alignment, so unloading has to be off the carriageway. A narrow entrance hall with a turn into the back of the house caps the longest piece we can physically get in, whatever the run itself measures. That is why the fitting line on a quote reflects manpower and time rather than square metres. It appears as its own line rather than buried in a rate.

Worktop installation, worktop replacement and worktop design & quotation, in that order. Households sharing a house tend to want two prep areas rather than one, which usually means an island as well as a perimeter run. The carcasses have to be sound, because stone is several times the weight of what is coming off. A day, not a project. The 1960s houses often have the kitchen a step above the hall on a raised slab, which changes the finished worktop height, so we set out from the cabinet tops rather than a stated 900mm.

Galley runs are usually short enough to come out of a single slab, so the material band you choose does more to the total than the room shape does. On the day that means dry-laying the whole layout first and only then pulling and bonding the joins. Dry-lay first, always. Legs bottoming out on hard concrete or an uneven screed mean the tops of the carcasses are not one plane, and that is picked up at template rather than on fitting day. The old top has been hiding it, so the first honest look at it happens when the laminate comes off. Found at template, not on fit day. Material runs from £110 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines rather than rolled into one figure.

The householder is normally on site at template, and that is the right time to settle sink position, tap centres and overhang rather than agree them by email. If the carcasses are tired the honest answer is that stone will find that out, and it is better said before than after. Units kept, surface changed. Tell us the building when you book and the lift, the stair turn and any freeholder notice get built into the day rather than found on it.