Splashbacks and upstands in Addington

Yes. Addington is on the patch, and the postcodes we work here are CR0. It is worked on our south London run, along with the rest of Croydon. Gravel and block paving both look like hard standing and neither takes a loaded trolley, so the run from tail lift to door gets boarded. Splashbacks are normally the last thing off, so a short parking window is exactly when they get rushed. Handling is where these pieces get damaged. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Walls look modern and are not: block or breeze with a skim that has been patched over decades, so dry-laying and scribing still apply. Post-war terraces are typically blockwork or early lightweight block with a hard render coat, and the kitchen has usually been reconfigured at least once, leaving patched areas of newer plaster next to original render that sit at different depths. The wall makes that decision, not the brochure. The 1960s houses often have the kitchen a step above the hall on a raised slab, which changes the finished worktop height, so we set out from the cabinet tops rather than a stated 900mm.

The village lanes are narrow with a sharp bend and no pavement in places, and the tram runs through on its own alignment, so unloading has to be off the carriageway. Everything comes through the front door and down the hall, so the tightest point on the route is usually the newel post at the foot of the stairs. It is usually the full-height panels rather than the tops that will not make the turn, and that only shows up when they arrive. Joint positions follow from that.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop installation, worktop replacement and worktop design & quotation. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. A second kitchen or a kitchenette in an annexe is a small job with the same fixed template, fabrication and fitting lines as a large one. Splashbacks and upstands are cut from the same slab run at the same time, which is the only way the batch actually matches. Sockets final before template. Where an annexe has been built or converted, its floor and its walls are newer than the main house and behave differently under the same run. Socket and switch positions have to be final before templating, because a cut-out in the wrong place means a new piece. Siliconed to the worktop, never grouted.

The catch with a galley is that both runs are seen end-on from the doorway, so any difference in overhang between the two reads immediately. The same shape decides where splashback pieces break, and a joint in a corner reads as a detail while one in a clear run reads as a mistake. Corners get their own pieces. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Legs bottoming out on hard concrete or an uneven screed mean the tops of the carcasses are not one plane, and that is picked up at template rather than on fitting day. It is usually what pushes a job towards a 100mm upstand instead of a full-height panel, because an upstand rides what a panel exposes. An upstand rides what a panel exposes. Boiler position, flue and any pipework drops must be settled and the wall skimmed level before templating the splashback run. The householder is normally on site at template, and that is the right time to settle sink position, tap centres and overhang rather than agree them by email. Splashbacks are cut from the same slab run as the tops, so they have to be decided before fabrication, not after. Decided before fabrication, not after.