Worktop installation in Alibon

Yes. Alibon is on the patch, and the postcodes we work here are RM10. It is worked on our east London run, along with the rest of Barking and Dagenham. On a street with no restrictions the constraint is other residents rather than a warden, so it is worth putting a cone or a car out early. The fitting slot is set around it, which is why we ask about it when the date is booked and not before we leave the yard. It is why the arrival time is what it is. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

These are built in dense concrete, so support for a peninsula or an end panel goes in with proper anchors rather than plugs. The stairwell half-landing is usually the tightest point on the whole route and it dictates the maximum piece. Walked, measured, protected, then lifted. Maisonette stairs here are external and often steep, so we cut to a length two people can carry safely up them rather than the longest possible piece.

Estate roads with easy parking, but maisonette blocks mean an external stair or shared entrance and a first-floor carry with a turn at the top. A walk-up with winders at every half-landing means the piece is rested and re-gripped on the way, so the crew size goes up before the piece size comes down. The fitting day is planned backwards from that point, before anything comes off the van. That is what the morning is planned around.

It is one of the three we do most here, behind worktop replacement. Same template visit, same workshop, same installers either way. A worktop replacement between tenancies is a single-day job by design, because the flat is not earning while it is empty. Where the window is fixed there is no second day to fall back on, so the prep list matters more than usual. Sealed before we leave. Where kitchens turn over between tenancies the priority is a surface that survives a decade of being treated as a chopping board. The fitting day is scheduled to suit that rather than to suit the diary. One visit, done properly.

The return piece is the awkward one on a slab: short, full depth, and rarely nesting neatly against the long lengths, so yield rather than area is what moves the material figure. On the day that means dry-laying the whole layout first and only then pulling and bonding the joins. Dry-lay first, always. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Boxing is rarely the same depth at worktop height as it is at floor level, so measuring it low down is the usual reason a top will not sit back. Rushing that is what leaves a gap you look at every morning for fifteen years. Dry-lay, mark, cut, then bond. Reserve a space as close to the block entrance as possible and clear the landing and stairs of prams, bikes and stored items. These kitchens tend to be compact and reasonably square, so the fixed template, fabrication and fitting lines are a larger share of the total than the stone is. The fitting day is arranged with whoever can actually give us access for the whole slot. Protection goes down first.