Worktop fabrication in Bankside

Yes. Bankside is on the patch, and the postcodes we work here are SE1. It is worked on our south east London run, along with the rest of Southwark. Underground loading has a height restriction, and a van with an A-frame on it is taller than the driver remembers. Where unloading has to happen in one go, the load order is planned so nothing has to come off twice. The load plan follows from it. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

A riverside block is a managed building with a booked goods lift, a loading bay and a concierge, and all three have to line up on the same day. The lift diagonal governs the longest piece, so the join count is fixed at nesting and cannot be revisited on the day. Every join over a gable, clear of every cut-out. Waterfall ends and mitred edges mean the fabrication tolerances matter more than the fitting - a 1mm out on the mitre shows on a 900mm drop.

Riverside towers with a single loading bay, booked service lift, protective floor coverings demanded by building management, and no kerbside anywhere near the entrance. A car that takes 2.4m on the diagonal will not take a three-metre worktop however it is stood, and there is no trimming it on the landing. Getting that wrong leaves a finished, machined piece that cannot reach the room, which is a remake rather than a trim. It is settled on the bench, not on site.

Yes. On the research for this patch it is the first of the three jobs listed, ahead of worktop installation and worktop design & quotation. Upgrading a builder-finish kitchen is mostly a swap, so the cost sits in the material choice rather than in the shape of the room. Pieces are dry-assembled and checked on the bench before anything is loaded. Same slab run, or it is not a match. Handover-spec kitchens are square, plumb and predictable, which means the join count is honest and driven by run length rather than by the building. Cutting several kitchens from different slabs and calling them matched is where firms get caught out. Nested for the job in front of us.

On a heavily veined stone the island and the run behind it are nested off the same area of slab so the movement relates across the room. Pieces are dry-assembled on the bench before dispatch so the corners are known to close before they leave the workshop. Every join sits over a gable. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A run can measure dead right at both ends and still belly out in the middle, which only appears once the template plots the intermediate points. The template drawing carries the real geometry through to the saw, and the piece is machined to it rather than trimmed to it later. The drawing decides it, not the fitter. Sink, tap and hob need to be with us before machining, along with confirmation of whether the island is getting a breakfast overhang, since anything past roughly 300mm unsupported needs steel let into the carcasses and that has to be built in, not added later. The same building type can arrive as a careful one-off kitchen or as a fast turnaround, and the honest answer is that they are priced differently. Changing an appliance after the nest is set means recutting the piece, not adjusting it. Changes cost a piece, not a tweak.