Worktop replacement in Beddington Corner

Yes. Beddington Corner is on the patch, and the postcodes we work here are CR4, SM6. It is worked on our south London run, along with the rest of Sutton. A drive that shelves towards the house needs the van chocked and the trolley controlled, since a loaded A-frame gathers speed quickly on a slope. Waste is the part people forget: the old laminate or tired granite has to be walked back to the van and it does not get lighter. Old tops out and new stone in, both through the same gap. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

A small room puts the sink, hob and tap cut-outs close together on one short length, and the bridge of stone left between them decides whether it can be cut in one piece. Lath-and-plaster and bowed brickwork mean we template for scribes rather than straight cuts, and each piece is offered up and eased in rather than dropped straight down. Units kept, surface changed, one day. Exposed services above the run in the converted buildings mean the upstand height has to be checked against the lowest pipe, not assumed at a standard 100mm.

Industrial traffic on the approach roads, narrow terraced streets with no off-street parking, and low railway and river bridges that dictate the route in. Carrying through the house means protecting the whole route first: floor boarded, banister padded, and the front door held open on a wedge rather than by hand. With no room to turn, the old top gets cut up in the kitchen instead, which is dusty work and needs the room emptied first. The strip-out is planned around it.

Yes. On the research for this patch it is the first of the three jobs listed, ahead of worktop templating and worktop splashbacks & upstands. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. Old tops out in the morning, new stone down and sealed the same afternoon. A plumber either side of us. Extension kitchens are usually specified long before they are buildable, so the run lengths on the drawing and the run lengths in the room are different numbers. The units stay and only the surface changes, so the whole job is one day rather than a kitchen refit. A day, not a project.

Galley runs are usually short enough to come out of a single slab, so the material band you choose does more to the total than the room shape does. Going from a 38mm laminate to 20mm or 30mm stone drops the surface, which shows against tiles, a window board and any freestanding appliance. The units stay, the surface changes. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Sill height gets settled with the template on site, because it is one of the few dimensions nobody has measured before we arrive. The old top has been hiding it, so the first honest look at it happens when the laminate comes off. The laminate has been covering it up. Have a plumber booked to disconnect the sink, tap and waste first thing and reconnect after we have gone, and clear the hallway and stairs completely so we can carry slabs through the house. The same building type can arrive as a careful one-off kitchen or as a fast turnaround, and the honest answer is that they are priced differently. If the carcasses are tired the honest answer is that stone will find that out, and it is better said before than after. Plumber either side of us.