Worktop templating in Bedford Park

Yes. Bedford Park is on the patch, and the postcodes we work here are W4. It is worked on our west London run, along with the rest of Hounslow. Enforcement zones rarely accept a trade van unloading stone as an exemption, so this gets sorted before the date is confirmed rather than argued about afterwards. The templating visit needs somewhere to stop for two or three hours, which is a different problem from unloading for twenty minutes. The templater needs a proper stop, not a pause. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Half-landings mean the back of the house sits at a slightly different level from the front, and a knocked-through kitchen crosses that line. The template plots the bow along the back of the run, which is why a tape reading taken beforehand never matches. Two to three hours, once the units are in. Listed and locally listed fabric means you cannot chase the wall for an upstand, so scribing to 140-year-old lime plaster is the actual job.

Conservation area controls mean skips and scaffold need permits, frontages are gravel with hedges rather than hardstanding, and the side gates are too narrow for a slab. Most stone goes in through the front door and down the hall. A side gate and a back door mean the stone never goes through the house at all, which keeps the dust and most of the risk outside. Door widths, turn diagonals and any change of level are recorded on the drawing alongside the run dimensions. It goes on the drawing with the run dimensions.

Yes. On the research for this patch it is the first of the three jobs listed, ahead of worktop installation and worktop splashbacks & upstands. Extension kitchens are usually specified long before they are buildable, so the run lengths on the drawing and the run lengths in the room are different numbers. The template visit is booked once the units are genuinely in, not when they are nearly in. The room as it is, not as it was drawn.

The catch with a galley is that both runs are seen end-on from the doorway, so any difference in overhang between the two reads immediately. The template records every angle in that shape as it actually is rather than as the plan drew it. One datum for the whole room. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A run can measure dead right at both ends and still belly out in the middle, which only appears once the template plots the intermediate points. One measurement never describes it, which is why a tape reading taken before the visit rarely matches the template. Plotted, not estimated. Units fixed and packed level over the sloping floor, walls replastered and dry at their final thickness (tiling and splashbacks go on after the worktop, never before), and the sink, tap and hob physically on site, with a Belfast sink built in and set at its finished height. The same building type can arrive as a careful one-off kitchen or as a fast turnaround, and the honest answer is that they are priced differently. A template booked hopefully around another trade is the commonest cause of a wasted visit. No stone is cut from a plan.