Worktop replacement in Bell Green

Yes. Bell Green is on the patch, and the postcodes we work here are SE26, SE6. It is worked on our south east London run, along with the rest of Lewisham. A drive that shelves towards the house needs the van chocked and the trolley controlled, since a loaded A-frame gathers speed quickly on a slope. A replacement is a two-way job, with old tops going out and new stone coming in, so the van needs to stay put across the whole day. Old tops out and new stone in, both through the same gap. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

The classic arrangement is the original back room with a later extension bolted onto it, so the kitchen is two ages of building in one room. What catches people out is the junction between the old floor and the extension floor, which is rarely at the same level, so a run carrying across it needs the units packed before stone goes on. What is under the old top is the real question. Straightforward suburban fits, but the 1930s back walls are rarely plumb so allow for scribing at the return.

Good vehicle access off the main roads and the retail park with drives or hardstandings on most houses, though the estate cul-de-sacs get tight for turning. A short hard approach with no steps means a full-length piece can be walked in flat by two people rather than turned up on edge. With no room to turn, the old top gets cut up in the kitchen instead, which is dusty work and needs the room emptied first. The strip-out is planned around it.

Yes. On the research for this patch it is the first of the three jobs listed, ahead of worktop installation and worktop templating. Rear and side-return extensions are where the islands appear, and an island is the piece that decides whether one slab does the kitchen or two. The carcasses have to be sound, because stone is several times the weight of what is coming off. A day, not a project. A new extension slab is not automatically level, and that wants checking before templating rather than after the stone is cut. Old tops out in the morning, new stone down and sealed the same afternoon. A day, not a project.

An L can be mitred at the corner for a continuous look or butt-jointed over the gable, and the two are different money and different risk. Going from a 38mm laminate to 20mm or 30mm stone drops the surface, which shows against tiles, a window board and any freestanding appliance. Height change is checked before we cut. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Where a corner is a couple of degrees off, a mitre cut to a theoretical ninety degrees opens on the wall side and there is no closing it afterwards. This is the commonest reason a replacement turns out to need more than a straight swap. Found at template, not on fit day. Unlock the side gate and clear the alley of bins, bikes and pots, and arrange a plumber for the sink and an electrician if the hob is hard-wired. The householder is normally on site at template, and that is the right time to settle sink position, tap centres and overhang rather than agree them by email. A replacement keeps the units and changes the surface, which is the least disruptive way to do this in an occupied property. Units kept, surface changed.