Worktop templating in Blackfriars

Yes. Blackfriars is on the patch, and the postcodes we work here are EC4V, EC4Y. It is worked on our the City run, along with the rest of the Square Mile. The realistic answer on a main road is an early slot, a spotter on the van and pieces staged in one movement rather than several trips. The templating visit needs somewhere to stop for two or three hours, which is a different problem from unloading for twenty minutes. It goes on the job sheet for the fitting crew. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Open-plan living makes the kitchen furniture rather than utility, so the island and the run behind it are nested off the same area of slab. New-build rooms are genuinely square, but they are dot-and-dab plasterboard, and the taped internal angle is where it goes wrong - the board bellies at the corner and the run picks up a few millimetres over the last 300mm. Two to three hours, once the units are in. Riverside peninsulas are seen from three sides, so pay for the extra polished edge and end profile rather than leaving a sawn edge facing the room.

Queen Victoria Street and the Embankment approaches are red route and bus-heavy with no stopping, so unloading is into a building's own basement bay or a booked side-street window, not the main road. Most buildings run a security desk with contractor sign-in, and the goods lift needs booking a few days ahead. Where the lift will not take the longest run we design a join in rather than gamble, because a piece that will not go up has to go back on the van. A template taken without walking the route produces a drawing that cuts beautifully and will not go in. It goes on the drawing with the run dimensions.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop installation, worktop fabrication and worktop replacement. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. No stone is ever cut from a plan, which is inconvenient exactly when a programme is tight. The room as it is, not as it was drawn.

Because a peninsula is seen from both sides, the underside of any overhang gets the same edge treatment as the top, which is easy to leave out of a spec. Join positions and vein direction are marked on the template drawing before it leaves site. The drawing leaves site complete. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Where a partition has been built off the floor screed rather than off the slab, it moves, and a mitre bonded across that corner is the first thing to open. It is recorded on the drawing with the run dimensions so the workshop is not guessing. That is why the visit takes two or three hours. Boards taped or skimmed and finished, units fixed back to the wall and levelled off, and the appliances on site - the wall must be at its final thickness on template day, so no tiler or splashback fitter gets ahead of the worktop. Where ownership is split across a building, the common parts belong to someone else and the carry route is negotiated rather than assumed. The template happens when the units are in, fixed and level, whoever is fitting them. Fitted, fixed and level, then we come.