Worktop replacement in Brick Lane

Yes. Brick Lane is on the patch, and the postcodes we work here are E1. It is worked on our east London run, along with the rest of Tower Hamlets. Unrestricted kerbside is straightforward as long as the space in front of the property is actually clear when the van arrives. A replacement is a two-way job, with old tops going out and new stone coming in, so the van needs to stay put across the whole day. The waste run is planned, not improvised. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

A flat over a shop is reached by a separate street door and a straight steep stair, and that stair is the whole access question. Post-war terraces have small, roughly square kitchens with a back door and a window in the middle of the run, so runs are short and joins are rare, but there are usually two corners and a window cill to work around in a couple of metres. Units kept, surface changed, one day. Above-shop flats mean everything gets planned in short jointed sections, and the stair, not the kitchen, sets the maximum piece size.

The street itself has heavy footfall from late morning until late at night, so realistically deliveries happen early and the van cannot sit for long. Flats above commercial units are reached by a separate side door and a very steep single-width stair, with no lift and no chance of turning a long piece at the top. Communal stairs get boarded and the handrail padded, and we walk the route with a tape before the first piece leaves the van. We plan the strip-out and the carry as one movement so the kitchen is only out of use for a single day. The strip-out is planned around it.

Yes. On the research for this patch it is the first of the three jobs listed, ahead of worktop templating and worktop splashbacks & upstands. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. Old tops out in the morning, new stone down and sealed the same afternoon. A day, not a project. Rear and side-return extensions are where the islands appear, and an island is the piece that decides whether one slab does the kitchen or two. The units stay and only the surface changes, so the whole job is one day rather than a kitchen refit. A day, not a project.

Peninsulas frequently land on a lightweight partition or on units that were never fixed down, and stone needs proper support under it before it goes on. Going from a 38mm laminate to 20mm or 30mm stone drops the surface, which shows against tiles, a window board and any freestanding appliance. Height change is checked before we cut. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A run can measure dead right at both ends and still belly out in the middle, which only appears once the template plots the intermediate points. This is the commonest reason a replacement turns out to need more than a straight swap. It is the usual surprise, and it is a known one. Empty the base units completely and have a plumber disconnect the sink, tap and any washing machine plumbed in under the worktop before we arrive. A street with houses in single occupation next to the same houses cut into flats produces two completely different jobs from the same elevation. If the carcasses are tired the honest answer is that stone will find that out, and it is better said before than after. Sound carcasses are the condition.