Kitchen worktops in Brixton

Yes. Estate flats and above-shop conversions dominate, with kitchens of 6 to 9 square metres taking a run of 2.4m to 3m plus a return, and services fixed where the block was built. Victorian terraces on the streets off Coldharbour Lane take a rear kitchen-diner with a peninsula rather than a full island. The realistic answer on a main road is an early slot, a spotter on the van and pieces staged in one movement rather than several trips. It rarely changes what we cut, but it does change how the pieces are stacked and strapped for the run out. It is decided in the yard, not at the kerb.

Victorian terrace, Above-shop flat, Large postwar estate and Interwar block. The rear wall is usually a single brick thick and has been rendered, patched and re-rendered, so it bows in and out along the length of the run. Lath-and-plaster on the party wall and the chimney breast returns almost never runs true, so a 100mm upstand bedded on silicone is the honest answer here, it rides the bow and hides the junction the worktop can never close on its own. The wall makes that decision, not the brochure.

The centre is a red route and bus corridor with market activity all day, so vehicle access effectively means before 9am. Above-shop flats are reached through a shared street door and a single steep flight, and estate blocks need booked lift access with a car too small for full lengths. The lift has to be booked and blanketed before anything moves, and that booking needs to cover the old tops coming out as well as the new stone going in. It is usually the full-height panels rather than the tops that will not make the turn, and that only shows up when they arrive. Joint positions follow from that.

Worktop replacement, worktop fabrication and worktop splashbacks & upstands, in that order. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. The units stay and only the surface changes, so the whole job is one day rather than a kitchen refit. A day, not a project. Nothing here goes in as one piece, plan a joint at the sink or hob as standard and finish the exposed end with a polished edge because there is rarely a wall to hide it against.

Peninsulas frequently land on a lightweight partition or on units that were never fixed down, and stone needs proper support under it before it goes on. Long runs almost never take a single panel, so the joint positions want agreeing before anything is templated. Joint placement is a decision, not an accident. The stone carries the scribe because the wall cannot be persuaded, so back edges are cut oversize and eased in rather than dropped straight down. Cut it square where it should be radiused and the piece will fail on the lift, not in the kitchen. The drawing decides it, not the fitter. Material runs from £110 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines rather than rolled into one figure.

These kitchens tend to be compact and reasonably square, so the fixed template, fabrication and fitting lines are a larger share of the total than the stone is. A replacement keeps the units and changes the surface, which is the least disruptive way to do this in an occupied property. Units kept, surface changed. Tell us the building when you book and the lift, the stair turn and any freeholder notice get built into the day rather than found on it.