Splashbacks and upstands in Brixton

Yes. Brixton is on the patch, and the postcodes we work here are SW9, SW2. It is worked on our south London run, along with the rest of Lambeth. The realistic answer on a main road is an early slot, a spotter on the van and pieces staged in one movement rather than several trips. Panels come off the van in one trip where possible, since a tall piece handled repeatedly is a piece asking to be chipped. One trip is always better than three. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Deep original skirting is often left in behind the units, standing them off the wall, so the back edge of the stone is plotted where the carcasses actually sit. Where a client wants a full-height piece behind the hob, it usually sits in the old chimney recess, and that recess is rarely square top to bottom or side to side, so it has to be templated as a trapezium rather than a rectangle. The wall makes that decision, not the brochure. Nothing here goes in as one piece, plan a joint at the sink or hob as standard and finish the exposed end with a polished edge because there is rarely a wall to hide it against.

The centre is a red route and bus corridor with market activity all day, so vehicle access effectively means before 9am. Above-shop flats are reached through a shared street door and a single steep flight, and estate blocks need booked lift access with a car too small for full lengths. Where the lift will not take the longest run we design a join in rather than gamble, because a piece that will not go up has to go back on the van. Splashback panels are lighter than a worktop and far more awkward, because a tall thin piece has to be carried on edge and cannot be tilted to clear a turn. It decides panel size before anything is cut.

It is one of the three we do most here, behind worktop replacement. Same template visit, same workshop, same installers either way. Extension kitchens are usually specified long before they are buildable, so the run lengths on the drawing and the run lengths in the room are different numbers. Splashbacks and upstands are cut from the same slab run at the same time, which is the only way the batch actually matches. Sockets final before template. Rear and side-return extensions are where the islands appear, and an island is the piece that decides whether one slab does the kitchen or two. Socket and switch positions have to be final before templating, because a cut-out in the wrong place means a new piece. Siliconed to the worktop, never grouted.

A peninsula is an island with one end tied to a run, which means the join between them has to be planned rather than allowed to happen. Upstands follow the run exactly, so every internal and external corner is a separate mitred or butted piece. Corners get their own pieces. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Where a corner is a couple of degrees off, a mitre cut to a theoretical ninety degrees opens on the wall side and there is no closing it afterwards. It is usually what pushes a job towards a 100mm upstand instead of a full-height panel, because an upstand rides what a panel exposes. An upstand rides what a panel exposes. The chimney breast recess must be replastered and fully dry, and the hob and extractor positions fixed, before anyone templates a full-height piece into it. Where a landlord or housing provider is involved there is a specification to meet and a process to follow, and both are settled before a date is offered. Full-height panels need the wall made good first, which is another trade and another timescale. Decided before fabrication, not after.