Worktop templating in Brondesbury Park

Yes. Brondesbury Park is on the patch, and the postcodes we work here are NW6. It is run from the Watford side, covering Hertfordshire & North London. Gravel and block paving both look like hard standing and neither takes a loaded trolley, so the run from tail lift to door gets boarded. The templating visit needs somewhere to stop for two or three hours, which is a different problem from unloading for twenty minutes. Two hours is the realistic figure. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Original joinery is deep and stands proud of the plaster, so the run is plotted to the units rather than to the wall behind them. One datum for the whole room, because a floor that falls end to end shows as a step between island and perimeter. No stone is ever cut from a plan. Multi-room jobs like this are three or four separate templates on the same visit, and the pantry and utility pieces should be cut from the same slab batch as the island for consistency.

Wide tree-lined roads with in-and-out driveways and gates, so vehicle access is among the best in Brent, but the front doors sit above several steps and the internal route to the rear is long. Everything comes through the front door and down the hall, so the tightest point on the route is usually the newel post at the foot of the stairs. The templater measures that route on the same visit, so the drawing leaves site already knowing the maximum piece. That is part of what the visit is for. Tell us what the approach looks like when you book the template and it gets built into the day rather than discovered on it.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop design & quotation, worktop installation and worktop fabrication. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. Where a single building holds several small kitchens, the work arrives as one job rather than four, and it should be cut off the same slab run so the batches genuinely match. Two to three hours on site, with the sink, tap and hob physically present. Appliances on site, not on order. A licensed shared house has fire-door and escape-route rules that decide how and when stone can be carried through the common parts. The template visit is booked once the units are genuinely in, not when they are nearly in. Units fitted, fixed and level first.

If the island is a few hundred millimetres longer than the usable length of a slab, a second slab gets bought to gain that overhang, and the whole slab is paid for rather than the part used. Join positions and vein direction are marked on the template drawing before it leaves site. The drawing leaves site complete. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A low sill over the sink run is what decides between an upstand and stone dying into a window board, and there is often less clearance than an upstand is tall. The laser plots it as it is, at the exact height the worktop will sit, and the drawing carries that through. Plotted, not estimated. All runs and the island carcass fixed down and levelled to one datum, with the sink, tap and hob on site - an island cannot be templated while it is still loose or sitting on packers. Where someone is living in the house through the work, the strip-out and the fit are planned so the kitchen is out of use for a day and not a week. A template booked hopefully around another trade is the commonest cause of a wasted visit. No stone is cut from a plan.