Worktop fabrication in Bruce Grove

Yes. Bruce Grove is on the patch, and the postcodes we work here are N17. It is worked on our north London run, along with the rest of Haringey. Without a bay the van ends up on a single yellow with a crew member watching it, which takes a pair of hands off the carry. Where unloading has to happen in one go, the load order is planned so nothing has to come off twice. The load plan follows from it. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

A villa cut into flats leaves kitchens in rooms that were never kitchens, with services run to wherever they could physically be made to reach. The other constraint is the hall: a piece has to come through the front door, round the newel at the foot of the stairs and through a doorway into the back kitchen, so we size the pieces to the tightest turn on that route before we nest anything, which sometimes means splitting a run that would otherwise have gone in whole. The bench proves it before the van moves. Because these are conversions, the kitchen is often above someone else's living room - drop cloths and a no-cutting-inside rule are worth agreeing with the freeholder up front.

The High Road end has heavy bus traffic, market activity and loading restrictions, and the side streets are permit-controlled. Converted houses have a communal front door, a shared hall with buggies and bikes in it, and a stair with a tight quarter-turn. Communal stairs get boarded and the handrail padded, and we walk the route with a tape before the first piece leaves the van. The maximum piece length is fixed at drawing stage and every join is placed over a cabinet gable from there. It is settled on the bench, not on site.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop replacement, worktop installation and worktop templating. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. Conversions put kitchens where the services could be made to reach rather than where they belong, so runs are short and interrupted. So the nesting is planned around it rather than around a standard kitchen. Proven on the bench before dispatch. In a converted house the flat entrance and the internal doorway are usually tighter than the communal stairs, and that is easy to overlook. Pieces are dry-assembled and checked on the bench before anything is loaded. Same slab run, or it is not a match.

A galley puts the sink on one side and the hob on the other, which spreads the cut-outs across two pieces instead of weakening one. Pieces are dry-assembled on the bench before dispatch so the corners are known to close before they leave the workshop. That is nested before any glass goes on the saw. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Walls that bow along their length are the normal condition rather than the exception, and a straight-cut back edge will show a shadow gap at one end and touch at the other. The template drawing carries the real geometry through to the saw, and the piece is machined to it rather than trimmed to it later. Radiused, polished, and clear of the joins. The sink and hob need to be on site and the run layout fixed before we start cutting, because moving a hob after the join position is set means recutting the whole piece. Where ownership is split across a building, the common parts belong to someone else and the carry route is negotiated rather than assumed. Changing an appliance after the nest is set means recutting the piece, not adjusting it. Changes cost a piece, not a tweak.