Kitchen worktops in Bruce Grove

Yes. Large Victorian houses that were built for single families and are now mostly split into flats, so kitchens end up in odd places - a former front parlour, a half-landing return room, or a back addition. Run lengths vary wildly between 1.8m and 3.5m in the same street. Without a bay the van ends up on a single yellow with a crew member watching it, which takes a pair of hands off the carry. The fitting slot is set around it, which is why we ask about it when the date is booked and not before we leave the yard. It is why the arrival time is what it is.

Victorian terrace, Victorian villa conversion and flat above shop. A villa cut into flats leaves kitchens in rooms that were never kitchens, with services run to wherever they could physically be made to reach. Alcoves either side of the breast are rarely the same width and rarely parallel, so each one is templated as its own piece with its own scribe. Recorded as it is, not as it was drawn.

The High Road end has heavy bus traffic, market activity and loading restrictions, and the side streets are permit-controlled. Converted houses have a communal front door, a shared hall with buggies and bikes in it, and a stair with a tight quarter-turn. A walk-up with winders at every half-landing means the piece is rested and re-gripped on the way, so the crew size goes up before the piece size comes down. The templater measures that route on the same visit, so the drawing leaves site already knowing the maximum piece. It goes on the drawing with the run dimensions.

Worktop replacement, worktop installation and worktop templating, in that order. Conversions put kitchens where the services could be made to reach rather than where they belong, so runs are short and interrupted. The fitting day is scheduled to suit that rather than to suit the diary. One visit, done properly. Because these are conversions, the kitchen is often above someone else's living room - drop cloths and a no-cutting-inside rule are worth agreeing with the freeholder up front.

Galley runs are usually short enough to come out of a single slab, so the material band you choose does more to the total than the room shape does. The existing layout is being kept, so the question is whether the old carcasses will take stone in that shape without more support. The units stay, the surface changes. Where a corner is a couple of degrees off, a mitre cut to a theoretical ninety degrees opens on the wall side and there is no closing it afterwards. Rushing that is what leaves a gap you look at every morning for fifteen years. Dry-lay, mark, cut, then bond. Material runs from £110 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines rather than rolled into one figure.

Where ownership is split across a building, the common parts belong to someone else and the carry route is negotiated rather than assumed. A half-day of access is not a fitting day, and it is better to say so at booking than to find out at eleven. Access for the whole slot, or a different day. Tell us the building when you book and the lift, the stair turn and any freeholder notice get built into the day rather than found on it.