Kitchen worktops in Tottenham

Yes. The N17 core is mostly modest terraces with the kitchen in a back addition, plus a steady flow of buy-to-let and HMO refits where the spec is durable rather than decorative. Single 2.4m to 3m runs, laminate coming out, mid-price quartz going in, layout unchanged. Gravel and block paving both look like hard standing and neither takes a loaded trolley, so the run from tail lift to door gets boarded. A van that has to move mid-fit costs the best part of an hour and takes a man off the tools to do it. It is why the arrival time is what it is.

Victorian terrace, interwar terrace, post-war estate block and new-build infill. Cornice, picture rails and deep skirting survive in converted rooms, so the run stands off the wall and the back edge follows the units rather than the plaster. In most Victorian terraces the kitchen sits in the back addition, so you get a narrow galley with one outside wall and nothing square to work off. Units kept, surface changed, one day.

The High Road is a continuous bus and cycle corridor with almost no legal kerbside stopping, so jobs are loaded from side streets. Terraces have no off-street parking and narrow hallways with a bend into the kitchen. Piece length is set by the internal diagonal of the lift car, not by the length of the slab. With no room to turn, the old top gets cut up in the kitchen instead, which is dusty work and needs the room emptied first. The strip-out is planned around it.

Worktop replacement, worktop installation and worktop splashbacks & upstands, in that order. Landlord work is scheduled around void periods, so the whole thing is a fixed window and the template date matters as much as the fitting date. The carcasses have to be sound, because stone is several times the weight of what is coming off. A day, not a project. Rental refits mean old units that have already been re-topped once - lift the existing laminate before you template, because the carcass tops underneath are frequently damaged.

The catch with a galley is that both runs are seen end-on from the doorway, so any difference in overhang between the two reads immediately. The same shape decides where splashback pieces break, and a joint in a corner reads as a detail while one in a clear run reads as a mistake. Joint placement is a decision, not an accident. A run can measure dead right at both ends and still belly out in the middle, which only appears once the template plots the intermediate points. On the day it means dry-laying, marking, and cutting the scribe on site before anything is bonded. Dry-lay, mark, cut, then bond. Material runs from £110 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines rather than rolled into one figure.

Access in a tenanted flat depends on the tenant, so the template and fitting dates are agreed with whoever actually holds the keys. Full-height panels need the wall made good first, which is another trade and another timescale. Decided before fabrication, not after. Tell us the building when you book and the lift, the stair turn and any freeholder notice get built into the day rather than found on it.