Kitchen worktops in Seven Sisters

Yes. Terraces along and behind West Green Road, many converted, with kitchens in the back addition and a fair number relocated into a former bedroom on the first floor. Runs are short - 2.1m to 2.6m - and the sink often sits off-centre under a window that was never designed for a kitchen. The realistic answer on a main road is an early slot, a spotter on the van and pieces staged in one movement rather than several trips. A replacement is a two-way job, with old tops going out and new stone coming in, so the van needs to stay put across the whole day. Old tops out and new stone in, both through the same gap.

Victorian terrace, flat above shop and post-war block. A flat over a shop is reached by a separate street door and a straight steep stair, and that stair is the whole access question. The fitting itself is about squaring up to walls that look modern and are not: block or breeze walls with a skim that has been patched over decades, so we still dry-lay and scribe rather than trust the template edge. That is the shape of the day.

The junction and the High Road are a red-route environment with bus lanes and no waiting, so unloading happens on the residential streets and everything is carried. Above-shop flats have a shared stair used by several tenancies. A walk-up with winders at every half-landing means the piece is rested and re-gripped on the way, so the crew size goes up before the piece size comes down. Finding it out on the morning costs the whole slot, because there is no second route to fall back on. That is what the morning is planned around.

Worktop replacement, worktop installation and worktop splashbacks & upstands, in that order. Party-wall and lease conditions in a converted building set when noisy work can happen, which shapes the fitting day more than the kitchen does. The fitting day is scheduled to suit that rather than to suit the diary. One visit, done properly. Where the kitchen has been moved upstairs the waste run is long and shallow, so the sink cut-out position is fixed by the plumbing - template around the existing waste, not around the cabinet centre.

The catch with a galley is that both runs are seen end-on from the doorway, so any difference in overhang between the two reads immediately. The existing layout is being kept, so the question is whether the old carcasses will take stone in that shape without more support. The units stay, the surface changes. Where a corner is a couple of degrees off, a mitre cut to a theoretical ninety degrees opens on the wall side and there is no closing it afterwards. On the day it means dry-laying, marking, and cutting the scribe on site before anything is bonded. Dry-lay, mark, cut, then bond. Material runs from £110 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines rather than rolled into one figure.

A street with houses in single occupation next to the same houses cut into flats produces two completely different jobs from the same elevation. The fitting day is arranged with whoever can actually give us access for the whole slot. Access for the whole slot, or a different day. Tell us the building when you book and the lift, the stair turn and any freeholder notice get built into the day rather than found on it.