Worktop fabrication in Canonbury

Yes. Canonbury is on the patch, and the postcodes we work here are N1. It is worked on our north London run, along with the rest of Islington. Enforcement zones rarely accept a trade van unloading stone as an exemption, so this gets sorted before the date is confirmed rather than argued about afterwards. Pieces are loaded in reverse fitting order so the first thing off the van is the first thing that goes down. That is the last thing settled before dispatch. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

The party wall is the straightest surface in the house and everything else has moved away from it over a century. Pieces are sized to the tightest turn on the route before anything is nested to the slab. Settled on the drawing, cut once. Rear extensions here are frequently new build butted against old brick, so allow a movement gap at the junction rather than running one uninterrupted top across the old and new wall line.

Traffic filters close several through routes and the CPZ is permit-heavy, so the van often stops a street away from the address. Long front gardens and railed steps make for a ten to twenty metre carry before the door, then a straight hall to the rear. Everything comes through the front door and down the hall, so the tightest point on the route is usually the newel post at the foot of the stairs. So the nesting is worked to the measured route first and to the slab second. The drawing carries that decision through to the saw.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop templating, worktop installation and worktop design & quotation. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. In a converted house the flat entrance and the internal doorway are usually tighter than the communal stairs, and that is easy to overlook. So the nesting is planned around it rather than around a standard kitchen. Proven on the bench before dispatch. A kitchen carved out of a larger room sits under whatever the original plan left behind, so the run frequently ends at a blocked doorway or a boxed-in service. Pieces are dry-assembled and checked on the bench before anything is loaded. Same slab run, or it is not a match.

A galley puts the sink on one side and the hob on the other, which spreads the cut-outs across two pieces instead of weakening one. The nest is laid out around that, with joins placed over cabinet gables and kept clear of every cut-out. The bench proves it before the van does. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

The stone carries the scribe because the wall cannot be persuaded, so back edges are cut oversize and eased in rather than dropped straight down. The template drawing carries the real geometry through to the saw, and the piece is machined to it rather than trimmed to it later. The drawing decides it, not the fitter. The sink and hob need to be on site and the run layout fixed before we start cutting, because moving a hob after the join position is set means recutting the whole piece. Where ownership is split across a building, the common parts belong to someone else and the carry route is negotiated rather than assumed. Changing an appliance after the nest is set means recutting the piece, not adjusting it. The approved drawing is the instruction.