Worktop fabrication in Mildmay

Yes. Mildmay is on the patch, and the postcodes we work here are N1, N16. It is worked on our north London run, along with the rest of Islington. Without a bay the van ends up on a single yellow with a crew member watching it, which takes a pair of hands off the carry. It rarely changes what we cut, but it does change how the pieces are stacked and strapped for the run out. The load plan follows from it. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

A long piece has to come through the front door, down the hall, round the newel post and through a doorway with a step down into the addition. Pieces are sized to the tightest turn on the route before anything is nested to the slab. Every join over a gable, clear of every cut-out. Narrow rear additions here often will not take a 600mm run plus a walkway, so check clearances at template and be ready to advise a 560mm depth instead.

A filtered-street scheme closes several through routes so the approach has to be planned street by street, and parking is permit-only Monday to Friday and tight all day. The terraces are shallow-set with two or three front steps and a hall under a metre wide. A narrow entrance hall with a turn into the back of the house caps the longest piece we can physically get in, whatever the run itself measures. Getting that wrong leaves a finished, machined piece that cannot reach the room, which is a remake rather than a trim. It is settled on the bench, not on site.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop replacement, worktop templating and worktop installation. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. A kitchen carved out of a larger room sits under whatever the original plan left behind, so the run frequently ends at a blocked doorway or a boxed-in service. Pieces are dry-assembled and checked on the bench before anything is loaded. Proven on the bench before dispatch. Conversions put kitchens where the services could be made to reach rather than where they belong, so runs are short and interrupted. So the nesting is planned around it rather than around a standard kitchen. Nested for the job in front of us.

The return piece is the awkward one on a slab: short, full depth, and rarely nesting neatly against the long lengths, so yield rather than area is what moves the material figure. Pieces are dry-assembled on the bench before dispatch so the corners are known to close before they leave the workshop. That is nested before any glass goes on the saw. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Where a corner is a couple of degrees off, a mitre cut to a theoretical ninety degrees opens on the wall side and there is no closing it afterwards. Internal corners are machined with a radius and polished, and kept well clear of any join or cut-out. The drawing decides it, not the fitter. The sink and hob need to be on site and the run layout fixed before we start cutting, because moving a hob after the join position is set means recutting the whole piece. The same building type can arrive as a careful one-off kitchen or as a fast turnaround, and the honest answer is that they are priced differently. Changing an appliance after the nest is set means recutting the piece, not adjusting it. Dry-assembled before it leaves.