Splashbacks and upstands in Castle Green

Yes. Castle Green is on the patch, and the postcodes we work here are RM9, IG11. It is worked on our east London run, along with the rest of Barking and Dagenham. Off-street parking means the van stays put all day, so tools, packers and the offcut we would rather have than not are all within reach. Panels come off the van in one trip where possible, since a tall piece handled repeatedly is a piece asking to be chipped. One trip is always better than three. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Original quarry-tiled floors sit lower than a later screed, so a run crossing that junction needs the units packed to one level. These kitchens are nearly always retiled at least twice, and stripping the old tiles takes the bottom course of plaster with it because the original laminate top ran underneath the tiles rather than up to them. The wall makes that decision, not the brochure. When we run a top across a removed wall line the two floor levels rarely match, so the base units get levelled to a datum line, not to the floor.

Reasonable residential streets but bounded by major roads, so route planning matters more than parking; most houses have some frontage to pull onto. A short hard approach with no steps means a full-length piece can be walked in flat by two people rather than turned up on edge. Where the route is tight we break a long splashback at a natural vertical joint instead of forcing one panel through. That is agreed at template, not on fitting day.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop installation, worktop replacement and worktop templating. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. Splashbacks and upstands are cut from the same slab run at the same time, which is the only way the batch actually matches. Same batch, same run, same day. Extension kitchens are usually specified long before they are buildable, so the run lengths on the drawing and the run lengths in the room are different numbers. Ordered later from a different batch, the match is not reliable exactly where the pieces meet. Sockets final before template.

Galley runs are usually short enough to come out of a single slab, so the material band you choose does more to the total than the room shape does. The same shape decides where splashback pieces break, and a joint in a corner reads as a detail while one in a clear run reads as a mistake. Joint placement is a decision, not an accident. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Legs bottoming out on hard concrete or an uneven screed mean the tops of the carcasses are not one plane, and that is picked up at template rather than on fitting day. A tall panel that fits at the worktop will stand off the wall at the top unless the wall is dubbed out or the panel is scribed. Scribed, dubbed out, or set proud. Pick one. The old tiling must be off and the wall made good and dry before templating, not on fitting day. Owner-occupied kitchens are usually being done once, which is why the edge profile, the vein direction and where a join falls are worth the conversation. A 100mm upstand is the low-maintenance answer, and full-height stone is the one that has to be committed to early. Decided before fabrication, not after.