Splashbacks and upstands in Goresbrook

Yes. Goresbrook is on the patch, and the postcodes we work here are RM9. It is worked on our east London run, along with the rest of Barking and Dagenham. On a street with no restrictions the constraint is other residents rather than a warden, so it is worth putting a cone or a car out early. Splashbacks are normally the last thing off, so a short parking window is exactly when they get rushed. Handling is where these pieces get damaged. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

These are small blocks with a single stair, no lift, and a communal door that will not stay open on its own. Patched plaster next to original render sits at different depths, and that step is exactly what an upstand covers. Cut from the same slab run as the tops. Modern infill units here are 560-570mm deep rather than 600mm, so the overhang is set on site once we see what has actually been fitted.

Straightforward estate streets north of the railway; the closer you get to the A13 and the industrial edge, the more the roads carry heavy traffic and the less sense it makes to unload on them. Door width, hall width and the diagonal at the turn are three separate measurements, and it is the diagonal that catches people out. It is usually the full-height panels rather than the tops that will not make the turn, and that only shows up when they arrive. That is agreed at template, not on fitting day.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop replacement, worktop installation and worktop templating. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. Upgrading a builder-finish kitchen is mostly a swap, so the cost sits in the material choice rather than in the shape of the room. Ordered later from a different batch, the match is not reliable exactly where the pieces meet. Siliconed to the worktop, never grouted. Handover-spec kitchens are square, plumb and predictable, which means the join count is honest and driven by run length rather than by the building. Splashbacks and upstands are cut from the same slab run at the same time, which is the only way the batch actually matches. Same batch, same run, same day.

The catch with a galley is that both runs are seen end-on from the doorway, so any difference in overhang between the two reads immediately. The same shape decides where splashback pieces break, and a joint in a corner reads as a detail while one in a clear run reads as a mistake. Joint placement is a decision, not an accident. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Legs bottoming out on hard concrete or an uneven screed mean the tops of the carcasses are not one plane, and that is picked up at template rather than on fitting day. It is usually what pushes a job towards a 100mm upstand instead of a full-height panel, because an upstand rides what a panel exposes. An upstand rides what a panel exposes. Boiler position, flue and any pipework drops must be settled and the wall skimmed level before templating the splashback run. Owner-occupied kitchens are usually being done once, which is why the edge profile, the vein direction and where a join falls are worth the conversation. Splashbacks are cut from the same slab run as the tops, so they have to be decided before fabrication, not after. The wall has to be ready.