Worktop installation in Goresbrook

Yes. Goresbrook is on the patch, and the postcodes we work here are RM9. It is worked on our east London run, along with the rest of Barking and Dagenham. Where the van can pull up level with the gate the pieces are handled the fewest times, which is what actually protects them. A van that has to move mid-fit costs the best part of an hour and takes a man off the tools to do it. It is why the arrival time is what it is. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Construction is blockwork with a render or a brick skin, so the walls are reasonably true and take a fixing properly. The fitting itself is about squaring up to walls that look modern and are not: block or breeze walls with a skim that has been patched over decades, so we still dry-lay and scribe rather than trust the template edge. That is the shape of the day. Modern infill units here are 560-570mm deep rather than 600mm, so the overhang is set on site once we see what has actually been fitted.

Straightforward estate streets north of the railway; the closer you get to the A13 and the industrial edge, the more the roads carry heavy traffic and the less sense it makes to unload on them. Everything comes through the front door and down the hall, so the tightest point on the route is usually the newel post at the foot of the stairs. We walk the route with a tape and protect it end to end before the first piece is lifted. It gets checked before the first piece is lifted.

It is one of the three we do most here, behind worktop replacement. Same template visit, same workshop, same installers either way. Developer-fitted kitchens come with thin cam-lock carcasses, which are fine under laminate and want bracing before stone goes on them. One visit, with the sink and hob seated and sealed before we leave. The prep list is not optional. Upgrading a builder-finish kitchen is mostly a swap, so the cost sits in the material choice rather than in the shape of the room. The fitting day is scheduled to suit that rather than to suit the diary. Sealed before we leave.

A galley puts the sink on one side and the hob on the other, which spreads the cut-outs across two pieces instead of weakening one. Joins are pulled with suction clamps and finished flush, then colour-matched, which is the last thing done rather than the first. The join is the last thing finished. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Level has to hold across the whole room rather than along one wall, or a floor that falls end to end shows as a step where two pieces meet. On the day it means dry-laying, marking, and cutting the scribe on site before anything is bonded. Eased in, never forced. Unlock any rear or shared path gate and clear both the hall and the back approach so we can choose the better route on the day. Where someone is living in the house through the work, the strip-out and the fit are planned so the kitchen is out of use for a day and not a week. Floors and units are protected before anything comes through the door, communal or otherwise. Protection goes down first.