Kitchen worktops in Charville

Yes. Ex-local semis and terraces largely on their original footprint, runs of around 2.7m with the back door in the corner, and refits driven by landlords and first-time buyers rather than designers. Where the van can pull up level with the gate the pieces are handled the fewest times, which is what actually protects them. A replacement is a two-way job, with old tops going out and new stone coming in, so the van needs to stay put across the whole day. Old tops out and new stone in, both through the same gap.

1930s estate semi, postwar terrace and ex-local housing. An ex-council house is solidly built to a standard plan, with the kitchen at the rear and a back door next to it. Ex-council flats and maisonettes are built in dense concrete and blockwork, so anything that has to be fixed back, such as brackets under a peninsula or support for an end panel, goes in with proper anchors and an SDS rather than plasterboard fixings. What is under the old top is the real question.

Wide estate roads with grass verges and paved hardstanding, no restrictions, and you can generally park directly outside the door. Where the van stands level with the front of the house a piece gets handled twice instead of five times, and stone breaks on handling rather than on the road. Worth remembering that the old tops have to come out the way the new ones come in, and a laminate run is easier to remove in one length than to carry in one. It sets what the day actually looks like.

Worktop replacement, worktop installation and worktop splashbacks & upstands, in that order. Where kitchens turn over between tenancies the priority is a surface that survives a decade of being treated as a chopping board. The units stay and only the surface changes, so the whole job is one day rather than a kitchen refit. A day, not a project. Original mid-century base units are 500mm deep, so a modern 600mm top overhangs badly and you either replace the carcasses or accept a large front oversail.

A galley puts the sink on one side and the hob on the other, which spreads the cut-outs across two pieces instead of weakening one. The same shape decides where splashback pieces break, and a joint in a corner reads as a detail while one in a clear run reads as a mistake. Joint placement is a decision, not an accident. A boxed soil stack or service riser in the corner of a run eats into the worktop depth and has to be scribed around rather than cut square. On the day it means dry-laying, marking, and cutting the scribe on site before anything is bonded. Dry-lay, mark, cut, then bond. Material runs from £110 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines rather than rolled into one figure.

Where ownership is split across a building, the common parts belong to someone else and the carry route is negotiated rather than assumed. A replacement keeps the units and changes the surface, which is the least disruptive way to do this in an occupied property. Units kept, surface changed. Tell us the building when you book and the lift, the stair turn and any freeholder notice get built into the day rather than found on it.