Splashbacks and upstands in Colliers Wood

Yes. Colliers Wood is on the patch, and the postcodes we work here are SW19, CR4. It is worked on our south west London run, along with the rest of Merton. Underground loading has a height restriction, and a van with an A-frame on it is taller than the driver remembers. Splashbacks are normally the last thing off, so a short parking window is exactly when they get rushed. Handling is where these pieces get damaged. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Dot-and-dab plasterboard bellies at a taped internal angle, so the run picks up a few millimetres over the last 300mm and a plan-angle mitre will not close. The plasterboard is genuinely flat here, so a full-height splashback sits well and a slim upstand looks almost redundant, but the sockets are the problem, because they are set out to the developer's original kitchen and often land at odd heights or right on a joint line. Cut from the same slab run as the tops. Developer kitchens here are built to a tight 600mm module with the sink already cut into a fixed position, so measure the existing cutouts before quoting a straight swap.

The new blocks have loading bays and a goods lift but both need booking with the concierge and there is a hard time limit on the bay. The older terraces sit on streets that back onto the river and industrial units, so vans get boxed in by delivery traffic on the A24. Where the lift will not take the longest run we design a join in rather than gamble, because a piece that will not go up has to go back on the van. Where the route is tight we break a long splashback at a natural vertical joint instead of forcing one panel through. It decides panel size before anything is cut.

It is one of the three we do most here, behind worktop replacement. Same template visit, same workshop, same installers either way. Handover-spec kitchens are square, plumb and predictable, which means the join count is honest and driven by run length rather than by the building. Socket and switch positions have to be final before templating, because a cut-out in the wrong place means a new piece. Sockets final before template. Housings and integrated appliances are set out for a 38mm laminate top, so dropping to 20mm or 30mm stone changes the clearances and needs checking before anything is cut. Ordered later from a different batch, the match is not reliable exactly where the pieces meet. Siliconed to the worktop, never grouted.

Galley runs are usually short enough to come out of a single slab, so the material band you choose does more to the total than the room shape does. Upstands follow the run exactly, so every internal and external corner is a separate mitred or butted piece. Joint placement is a decision, not an accident. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Boxing is rarely the same depth at worktop height as it is at floor level, so measuring it low down is the usual reason a top will not sit back. Where the wall cannot be made good, setting the stone deliberately proud on a subframe with a shadow gap reads as a detail rather than a bad fit. An upstand rides what a panel exposes. Any socket you intend to move must be moved and re-plastered before templating, because a cut-out in the wrong place means a new piece of stone. Owner-occupied kitchens are usually being done once, which is why the edge profile, the vein direction and where a join falls are worth the conversation. Full-height panels need the wall made good first, which is another trade and another timescale. Same slab run as the tops.